[PATCH 2/5] net/at91_ether: select MACB in Kconfig
Jean-Christophe PLAGNIOL-VILLARD
plagnioj at jcrosoft.com
Sun Oct 21 14:31:22 EDT 2012
On 16:23 Sun 21 Oct , Joachim Eastwood wrote:
> Now that HAVE_NET_MACB is gone let's just select MACB to
> satisfy the dependecies in at91_ether.
>
> PHYLIB will then by selected by MACB.
>
> Signed-off-by: Joachim Eastwood <manabian at gmail.com>
> ---
> drivers/net/ethernet/cadence/Kconfig | 2 +-
> drivers/net/ethernet/cadence/Makefile | 2 +-
> 2 files changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/net/ethernet/cadence/Kconfig b/drivers/net/ethernet/cadence/Kconfig
> index 5d1ea30..f6d0956 100644
> --- a/drivers/net/ethernet/cadence/Kconfig
> +++ b/drivers/net/ethernet/cadence/Kconfig
> @@ -23,7 +23,7 @@ config ARM_AT91_ETHER
> tristate "AT91RM9200 Ethernet support"
> depends on ARM && ARCH_AT91RM9200
> select NET_CORE
> - select PHYLIB
> + select MACB
no the ether and macb are two diferrent drivers for 2 IPs from cadence
the ehter does not need the macb
Best Regards,
J.
> ---help---
> If you wish to compile a kernel for the AT91RM9200 and enable
> ethernet support, then you should always answer Y to this.
> diff --git a/drivers/net/ethernet/cadence/Makefile b/drivers/net/ethernet/cadence/Makefile
> index 798b1e0..9068b83 100644
> --- a/drivers/net/ethernet/cadence/Makefile
> +++ b/drivers/net/ethernet/cadence/Makefile
> @@ -2,5 +2,5 @@
> # Makefile for the Atmel network device drivers.
> #
>
> -obj-$(CONFIG_ARM_AT91_ETHER) += at91_ether.o macb.o
> +obj-$(CONFIG_ARM_AT91_ETHER) += at91_ether.o
> obj-$(CONFIG_MACB) += macb.o
> --
> 1.7.12.4
>
More information about the linux-arm-kernel
mailing list