[PATCH 5/6] ARM: ux500: Enable SDI4 port on the u9540 when booting with Device Tree

[Lee Jones]

On Wed, 10 Oct 2012, Jean-Christophe PLAGNIOL-VILLARD wrote:

> On 16:18 Wed 10 Oct     , Lee Jones wrote:
> > Here we add the device node for the SDI4 (MMC) port to the u9540
> > Device Tree source file. This will allow successful probing of
> > the internal MMC storage device when booting with DT enabled.
> > 
> > Acked-by: Linus Walleij <linus.walleij at linaro.org>
> > Signed-off-by: Lee Jones <lee.jones at linaro.org>
> > ---
> >  arch/arm/boot/dts/u9540.dts |   12 +++++++++++-
> >  1 file changed, 11 insertions(+), 1 deletion(-)
> > 
> > diff --git a/arch/arm/boot/dts/u9540.dts b/arch/arm/boot/dts/u9540.dts
> > index 28efe20..2dade76 100644
> > --- a/arch/arm/boot/dts/u9540.dts
> > +++ b/arch/arm/boot/dts/u9540.dts
> > @@ -21,7 +21,6 @@
> >  	};
> >  
> >  	soc-u9500 {
> > -
> why?

My OCD shining though. It's either this or I create a seperate patch
for it. I think sneaking it in here is better.

> >  		uart at 80120000 {
> >  			status = "okay";
> >  		};
> > @@ -33,5 +32,16 @@
> >  		uart at 80007000 {
> >  			status = "okay";
> >  		};
> > +
> > +		// On-board eMMC
> no c++ comment

Single line comments are perfectly valid in DTS(I) files.

See: Documentation/devicetree/booting-without-of.txt

> > +		sdi4_per2 at 80114000 {
> > +			arm,primecell-periphid = <0x10480180>;
> > +		        max-frequency = <50000000>;
> > +			bus-width = <8>;
> > +			mmc-cap-mmc-highspeed;
> > +			vmmc-supply = <&ab8500_ldo_aux2_reg>;
> you need add the pinctrl here

Pinctrl will come in time. We have a priority list.

-- 
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog