[PATCH] Add McSPI devices found in AM33xx SoC to dtsi

[Philip, Avinash]

On Tue, Oct 09, 2012 at 19:54:28, Phil Pokorny wrote:
> On Oct 9, 2012, at 3:36 AM, "Philip, Avinash" <avinashphilip at ti.com>
> wrote:
> 
> > On Tue, Oct 09, 2012 at 10:40:58, Phil Pokorny wrote:
> >> We're using the BeagleBone for a project and we need the SPI devices
> >> available and configured with all available chip selects.
> >>
> >> Please accept the following patch to add these to the base .dtsi file
> >> so they can then be enabled in the beaglebone specific .dts with
> >> minimal fuss.
> >
> > Patch for adding MCSPI in am33xx.dtsi already been sent by me.
> > https://lkml.org/lkml/2012/9/18/32
> 
> Thank you for responding.
> 
> Was that accepted?  It didn't seem to be in the Linux-omap git tree I
> cloned. I need to check the Torvalds mainline kernel.

It's not accepted.
> 
> I believe the number of chip selects on spi1 is incorrect. There is
> only one (1) CS shown in the hardware documentation for AM33xx.

No, number of chip select for SPI 1 is 2. AM33xx TRM says

TRM section
24.1.2 Unsupported McSPI Features

Feature 			Reason
Chip selects 2 and 3	Not pinned out

Also you can see soc pin outs.

> 
> Is OMAP4-McSPI the best match for the hardware?

Yes.

> The mcspi driver appears to differ only in the register offset used.
> A hard coded zero value for omap2 and a named constant for omap4.
> The hardware manual for the AM33xx shows the register map
>starting at zero.

You can see register offset for am33xx (it is defined at offset 0x100).
Hence offset is required in am33xx.

Thanks
Avinash

> Thank you,
> Phil P.
> >
>