[PATCH 0/2] ARM: OMAP: SmartReflex: pass device dependent data via platform data

[jean.pihet at newoldbits.com]

From: Jean Pihet <j-pihet at ti.com>

Remove the device dependent code (ex. cpu_is_xxx()) and settings
from the driver code and instead pass them via the platform
data. This allows a clean separation of the driver code and the platform
code, as required by the move of the platform header files to
include/linux/platform_data.

Note about the smartreflex functional clocks: the smartreflex fclks
are derived from sys_clk and are renamed "smartreflex.%d". Since the
smartreflex device names and the functional clock names are identical
the device driver code uses them to control the functional clocks.

Based on mainline 3.6.0. Boot tested on OMAP3&4 platforms.
										
Jean Pihet (2):
  ARM: OMAP: hwmod: align the SmartReflex fck names
  ARM: OMAP: SmartReflex: pass device dependent data via platform data

 arch/arm/mach-omap2/clock33xx_data.c       |   12 +++----
 arch/arm/mach-omap2/clock3xxx_data.c       |   12 +++----
 arch/arm/mach-omap2/clock44xx_data.c       |    6 ++--
 arch/arm/mach-omap2/omap_hwmod_3xxx_data.c |    8 ++---
 arch/arm/mach-omap2/sr_device.c            |   13 +++++++
 drivers/power/avs/smartreflex.c            |   54 +++++++++-------------------
 include/linux/power/smartreflex.h          |   14 ++++++--
 7 files changed, 61 insertions(+), 58 deletions(-)

-- 
1.7.10.4