[PATCH 1/1] ARM: OMAP2+: enable support for GPIO connected LEDs

[Javier Martinez Canillas]

Many OMAP boards use GPIO LEDs to notify status to the user
on boot. So, it is good to have by default support for GPIO
connected LEDs as well as some commonly used triggers.

Signed-off-by: Javier Martinez Canillas <javier.martinez at collabora.co.uk>
---
 arch/arm/configs/omap2plus_defconfig |    8 ++++++++
 1 files changed, 8 insertions(+), 0 deletions(-)

diff --git a/arch/arm/configs/omap2plus_defconfig b/arch/arm/configs/omap2plus_defconfig
index 6333e96..7c6cbdf 100644
--- a/arch/arm/configs/omap2plus_defconfig
+++ b/arch/arm/configs/omap2plus_defconfig
@@ -193,6 +193,14 @@ CONFIG_MMC_UNSAFE_RESUME=y
 CONFIG_SDIO_UART=y
 CONFIG_MMC_OMAP=y
 CONFIG_MMC_OMAP_HS=y
+CONFIG_NEW_LEDS=y
+CONFIG_LEDS_CLASS=y
+CONFIG_LEDS_GPIO=y
+CONFIG_LEDS_TRIGGERS=y
+CONFIG_LEDS_TRIGGER_HEARTBEAT=y
+CONFIG_LEDS_TRIGGER_BACKLIGHT=y
+CONFIG_LEDS_TRIGGER_GPIO=y
+CONFIG_LEDS_TRIGGER_DEFAULT_ON=y
 CONFIG_RTC_CLASS=y
 CONFIG_RTC_DRV_TWL92330=y
 CONFIG_RTC_DRV_TWL4030=y
-- 
1.7.7.6