[PATCH 3/3] ARM: dts: AM33XX: Add memory resource to d_can node
AnilKumar, Chimata
anilkumar at ti.com
Wed Nov 21 00:45:45 EST 2012
On Tue, Nov 20, 2012 at 15:56:32, Marc Kleine-Budde wrote:
> On 11/20/2012 11:23 AM, AnilKumar, Chimata wrote:
> > On Tue, Nov 20, 2012 at 15:43:04, Marc Kleine-Budde wrote:
> >> On 11/14/2012 07:08 PM, AnilKumar Ch wrote:
> >>> Add a new address space/memory resource to d_can device tree node. D_CAN
> >>> RAM initialization is achieved through RAMINIT register which is part of
> >>> AM33XX control module address space. D_CAN RAM init or de-init should be
> >>> done by writing instance corresponding value to control module register.
> >>>
> >>> Till we have a separate control module driver to write to control module,
> >>> d_can driver will handle the register writes to control module by itself.
> >>> So a new address space to represent this control module register is added
> >>> to d_can driver.
> >>>
> >>> Signed-off-by: AnilKumar Ch <anilkumar at ti.com>
> >>
> >> This does not apply to net-next/master:
> >>
> >> Applying: ARM: dts: AM33XX: Add memory resource to d_can node
> >> error: patch failed: arch/arm/boot/dts/am33xx.dtsi:227
> >> error: arch/arm/boot/dts/am33xx.dtsi: patch does not apply
> >> Patch failed at 0003 ARM: dts: AM33XX: Add memory resource to d_can node
> >>
> >
> > Marc,
> >
> > Sorry about this DT changes are present in linux-omap.
> >
> > Could you please take the driver changes only and ACK on remaining will
> > help.
>
> Will do - I'm currently looking at the driver.
>
Hi Marc,
Please ACK this patch as well.
Thanks
AnilKumar
More information about the linux-arm-kernel
mailing list