[PATCH 0/5] ARM: Kirkwood: Use fixed regulators
Andrew Lunn
andrew at lunn.ch
Sat Nov 17 10:00:08 EST 2012
Hi Folks
Forgot to mention, these patches apply on top of the gpio-poweroff
patches, which has been ACKed by the appropriate maintainer.
Andrew
On Sat, Nov 17, 2012 at 03:46:09PM +0100, Andrew Lunn wrote:
> A few Kirkwood boards use a GPIO line to enable power to subsystems,
> eg USB or SATA devices. Use the regulator framework to control these
> GPIO lines, and describe them in DT rather than C code in the board
> files.
>
> Posted before as part of the bigger patchset.
>
> Andrew Lunn (5):
> ARM: Kirkwood: Enable regulator and fixed regulators.
> ARM: Kirkwood: Convert DNSKW to use regulators
> ARM: Kirkwood: Convert Dockstar to use regulators
> ARM: Kirkwood: Convert GoFlexNet to use regulators
> ARM: Kirkwood: Convert LSXL to use regulators
>
> arch/arm/boot/dts/kirkwood-dnskw.dtsi | 29 +++++++++++++++++++++++++++++
> arch/arm/boot/dts/kirkwood-dockstar.dts | 17 +++++++++++++++++
> arch/arm/boot/dts/kirkwood-goflexnet.dts | 17 +++++++++++++++++
> arch/arm/boot/dts/kirkwood-lsxl.dtsi | 29 +++++++++++++++++++++++++++++
> arch/arm/mach-kirkwood/Kconfig | 3 ++-
> arch/arm/mach-kirkwood/board-dnskw.c | 4 ----
> arch/arm/mach-kirkwood/board-dockstar.c | 4 ----
> arch/arm/mach-kirkwood/board-goflexnet.c | 4 ----
> arch/arm/mach-kirkwood/board-lsxl.c | 8 --------
> 9 files changed, 94 insertions(+), 21 deletions(-)
>
> --
> 1.7.10.4
>
More information about the linux-arm-kernel
mailing list