[PATCH v3 0/3] GPIO driver to turn power off

Andrew Lunn andrew at lunn.ch
Sat Nov 17 03:51:03 EST 2012


A few of the Kirkwood systems use a GPIO line to turn the power off on
shutdown. They request the GPIO line in the board setup code,
optionally setting it as an output and driving it inactive. They then
register a function for pm_power_off. At the end of the shutdown, this
function is called. The GPIO line is configured as an output, if not
already so, and then driven active. In order to cover the use case of
edges rather then levels, triggering power off, the GPIO line is then
toggled active and later inactive. This should allow the driver to be
used by PXA which also has boards using the same scheme.

The driver code was initially developed by Jamie Lentin and extended
to cover the PXA case by Andrew Lunn.

v1 -> v2: Moved to drivers/power/reset
v2 -> v3: Fixed polarity of IB62x0 GPIO
          Increased delay before WARN if the power does not go off.

Andrew Lunn (2):
  ARM: Kirkwood: Convert DNSKW to use gpio-poweroff.
  ARM: Kirkwood: Convert IB62x0 to use gpio-poweroff.

Jamie Lentin (1):
  power: Add simple poweroff-gpio driver

 .../devicetree/bindings/gpio/gpio-poweroff.txt     |   22 ++++
 arch/arm/boot/dts/kirkwood-dnskw.dtsi              |    5 +
 arch/arm/boot/dts/kirkwood-ib62x0.dts              |    6 +
 arch/arm/mach-kirkwood/Kconfig                     |    4 +
 arch/arm/mach-kirkwood/board-dnskw.c               |   12 --
 arch/arm/mach-kirkwood/board-ib62x0.c              |   13 --
 drivers/power/Kconfig                              |    3 +
 drivers/power/Makefile                             |    1 +
 drivers/power/reset/Kconfig                        |   15 +++
 drivers/power/reset/Makefile                       |    1 +
 drivers/power/reset/gpio-poweroff.c                |  129 ++++++++++++++++++++
 11 files changed, 186 insertions(+), 25 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/gpio/gpio-poweroff.txt
 create mode 100644 drivers/power/reset/Kconfig
 create mode 100644 drivers/power/reset/Makefile
 create mode 100644 drivers/power/reset/gpio-poweroff.c

-- 
1.7.10.4




More information about the linux-arm-kernel mailing list