[PATCH 2/2] ARM: ux500: Move board specific GPIO info out to subordinate DTS files

[Lee Jones]

GPIO numbers for the newly created gpio-regulator will differ from
board to board. Therefore it's not sensible to leave this information
in the top level DTSI file. Let's move them out to the DTS files
where they can correctly vary.

Signed-off-by: Lee Jones <lee.jones at linaro.org>
---
 arch/arm/boot/dts/dbx5x0.dtsi    |    2 --
 arch/arm/boot/dts/hrefprev60.dts |    7 +++++++
 2 files changed, 7 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/dbx5x0.dtsi b/arch/arm/boot/dts/dbx5x0.dtsi
index d8ba489..9f55363 100644
--- a/arch/arm/boot/dts/dbx5x0.dtsi
+++ b/arch/arm/boot/dts/dbx5x0.dtsi
@@ -638,8 +638,6 @@
 			regulator-name = "mmci-reg";
 			regulator-type = "voltage";
 
-			gpios = <&tc3589x_gpio 18 0x4>;
-			gpio-enable = <&tc3589x_gpio 17 0x4>;
 			states = <1800000 0x1
 				  2900000 0x0>;
 
diff --git a/arch/arm/boot/dts/hrefprev60.dts b/arch/arm/boot/dts/hrefprev60.dts
index b398946..eec29c4 100644
--- a/arch/arm/boot/dts/hrefprev60.dts
+++ b/arch/arm/boot/dts/hrefprev60.dts
@@ -37,5 +37,12 @@
 				reset-gpio = <&tc3589x_gpio 13 0x4>;
 			};
 		};
+
+		vmmci: regulator-gpio {
+			gpios = <&tc3589x_gpio 18 0x4>;
+			gpio-enable = <&tc3589x_gpio 17 0x4>;
+
+			status = "okay";
+		};
 	};
 };
-- 
1.7.9.5