[PATCH 0/2] Boottime: measure bootloader and kernel bootup time
Lee Jones
lee.jones at linaro.org
Thu Nov 15 05:35:28 EST 2012
On Thu, 15 Nov 2012, Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 10:04 Thu 15 Nov , Lee Jones wrote:
> > This patchset supplies a new tool which measures boottime inclusive
> > of bootloader involvement. It seems to be accurate and adds no
> > latency to the booting of the system.
> >
> > In the first round of testing we booted the kernel 3 times each with
> > boottime enabled and disabled. Actually, when it was disabled, the
> > code was completely removed from the kernel source and the kernel was
> > rebuilt. The difference between present & enabled and completely
> > removed was very little indeed. In fact, averaging out the 3 runs of
> > each, when boottime was enabled the system booted 4ms _faster_, go
> > figure!
> >
> > Enabled Disabled
> > 1st run 2.983093 2.985168
> > 2nd run 2.973266 2.971801
> > 3rd run 2.975402 2.987304
> > Average 2.977254 2.981424 -0.004171 (-4ms)
> >
> >
> > For the next round of testing, we delayed the bootloader for varying
> > amounts of time, then started to remove key components from kernel
> > functionality to see if the boottime system would pick-up on them.
> >
> > /* Hang around in the bootloader for a while. */
> > $ cat /sys/kernel/debug/boottime/summary
> > kernel: 42864 msecs
> > total: 42864 msecs
> > kernel: cpu0 system: 56% idle: 43% iowait: 0% irq: 0%
> > cpu1 system: 4% idle: 95% iowait: 0% irq: 0%
> >
> > /* Hang around in the bootloader for a smaller amount of time. */
> > kernel: 12351 msecs
> > total: 12351 msecs
> > kernel: cpu0 system: 56% idle: 43% iowait: 0% irq: 0%
> > cpu1 system: 2% idle: 97% iowait: 0% irq: 0%
> >
> > /* Instant boot. (1st run) */
> > kernel: 7833 msecs
> > total: 7833 msecs
> > kernel: cpu0 system: 55% idle: 44% iowait: 0% irq: 0%
> > cpu1 system: 3% idle: 96% iowait: 0% irq: 0%
> >
> > /* Instant boot. (2nd run) */
> > kernel: 7817 msecs
> > total: 7817 msecs
> > kernel: cpu0 system: 53% idle: 46% iowait: 0% irq: 0%
> > cpu1 system: 8% idle: 91% iowait: 0% irq: 0%
> >
> > /* Instant boot. (3rd run) */
> > kernel: 7747 msecs
> > total: 7747 msecs
> > kernel: cpu0 system: 56% idle: 42% iowait: 0% irq: 0%
> > cpu1 system: 2% idle: 97% iowait: 0% irq: 0%
> 7/8s? on a u9500 wow it's really slow
No, this is a u8500.
> I do 2/3s here
Really? You installed this quick.
Are you sure you did it correctly?
Don't forget, this times from power-on to userspace.
--
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog
More information about the linux-arm-kernel
mailing list