[PATCH v2 2/3] serial: mxs-auart: add the DMA support for mx28

[Huang Shijie]

于 2012年11月13日 17:42, Lauri Hintsala 写道:
> Hi Huang,
>
> DMA support doesn't work with latest stable v3.6.5 or development 
> 3.7-rc5 kernels. I get following error message when I open the serial 
> port /dev/ttyAPP0:
>
> [ 48.730000] mxs-auart 8006a000.serial: step 1 error
> [ 48.750000] mxs-auart 8006a000.serial: We can not start up the DMA.
>
I tested this patch set in imx28-evk board Rev C with linux-next-20121114.
it works fine.

Maybe you can try the linux-next code.

About the flow control:
If we do not enable the HW flow control, the data may lost. And I do not 
know how to handle with the Xon/Xoff when the DMA is supported.

Best Regards
Huang Shijie