[PATCH 1/2] ARM: kirkwood: Add Plat'Home OpenBlocks A6 support

[Andrew Lunn]

Hi Nobuhiro

> >> +     model = "Plat'Home OpenBlocksA6";
> >> +     compatible = "plathome,openblocks-a6", "marvell,kirkwood-88f6283", "marvell,kirkwood";
> >
> > Ah, interesting. A 88f6283. I'm a bit surprised this actually works!
> > This variant is not listed in kirkwood_id(). So do you see messages
> > like:
> >
> > "Device-Unknown"
> >
> > and
> >
> > "MPP setup: unknown kirkwood variant"
> 
> No, I can not see these message.
> 88f6283 is same as MV88F6282-Rev-A1. Because this has same CPU ID as
> MV88F6282-Rev-A1.

Ah. O.K.

Is it pin compatible? Please take a look at 

https://github.com/lunn/linux/blob/v3.7-rc2-pinctrl-v2/drivers/pinctrl/mvebu/pinctrl-kirkwood.c

and see if what is valid for 88f6282 is also valid for 88f6283.

If its not compatible, we need to add this variant to the table.

> What kind of value should I set here?

For the moment, keep to 88f6283. At the moment its not actually used.
However, when we add pinctrl we will need to this about this some
more, depending on if its pin compatible or not.

> >> +static unsigned int openblocks_a6_mpp_config[] __initdata = {
> >> +     MPP0_NF_IO2,
> >> +     MPP1_NF_IO3,
> >> +     MPP2_NF_IO4,
> >> +     MPP3_NF_IO5,
> >> +     MPP4_NF_IO6,
> >> +     MPP5_NF_IO7,
> >> +     MPP6_SYSRST_OUTn,
> >> +     /* MPP7_GPO, */
> >
> > Any reason not to actually have MPP7_GPO here?
> > Is it being used as a GPO line?
> 
> Yes. MPP7 is assigned to GPO in this target boatd.
> And GPO is not used.
> The following is also the same.
> If unnecessary, I will delete these lines.

If they are not used, i would not list them.
 
 Thanks for the quick response.

 Andrew