[PATCH] ARM: OMAP2+: timer: remove CONFIG_OMAP_32K_TIMER

Igor Grinberg grinberg at compulab.co.il
Mon Nov 12 02:24:59 EST 2012


On 11/12/12 08:38, Hiremath, Vaibhav wrote:
> On Sun, Nov 11, 2012 at 17:05:07, Igor Grinberg wrote:
>>
>>
>> On 11/08/12 20:34, Jon Hunter wrote:
>>>
>>> On 11/08/2012 12:17 PM, Paul Walmsley wrote:
>>>> On Thu, 8 Nov 2012, Jon Hunter wrote:
>>>>
>>>>> On 11/08/2012 11:58 AM, Paul Walmsley wrote:
>>>>>> On Thu, 8 Nov 2012, Jon Hunter wrote:
>>>>>>
>>>>>>> Igor was mentioning a h/w scenario where the 32kHz source is not
>>>>>>> present. However, I am not sure which devices support this and is
>>>>>>> applicable too.
>>>>>>
>>>>>> Pretty sure Igor is referring to the AM3517/3505.  This is very poorly 
>>>>>> documented, but can be observed in the AM3517 TRM Rev B (SPRUGR0B) Figure 
>>>>>> 4-23 "PRM Clock Generator" and the AM3517 DM Rev C (SPRS550C) Section 4 
>>>>>> "Clock Specifications".
>>>>>
>>>>> But AFAICT, even in that h/w configuration the internal 32k
>>>>> oscillator will be used
>>>>
>>>> Just to clarify, there's no internal 32k oscillator used on the 3517/3505; 
>>>> just a divider from the HF clock.
>>>
>>> Ah yes I see that now!
>>>
>>>>> and so the gptimer will still have a 32k clock source.
>>>>
>>>> That's a good question and you might want to check with Igor on that one,
>>>> the AM3517 TRM conflicts with the DM as to whether it's available to the 
>>>> GPTIMER or not :-(
>>>
>>> Well the external 32k and internal divided down version go through the
>>> same mux and so that seems to imply either they are both available to
>>> the gptimer or neither is.
>>
>> Yep, but the /800 do not get you the 32768...
>> and that makes the timer suck.
>> Of course this can be dealt with in the clock subsystem
>> (I remember Paul said that he will look into that), but it will take time.
>>
>> Also, what about having the sys_clk instead of 32k for higher precision?
>> Is that possible already (without my patch)?
>>
> 
> Yes, it is possible. You can choose it through bootargs.

Is the kernel command line the only way for doing this?
I personally dislike it, because it brings multiple maintenance problems.
This must be possible at least through DT.


-- 
Regards,
Igor.



More information about the linux-arm-kernel mailing list