[PATCH 3/6] ARM: integrator: remove static AP syscon mapping
Linus Walleij
linus.walleij at linaro.org
Sun Nov 11 19:52:52 EST 2012
This removes the static mapping for the AP system controller for
the device tree case. Fork the static mappings table and move
the system controller to only be statically mapped in the ATAG
boot path.
Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
---
arch/arm/mach-integrator/integrator_ap.c | 58 +++++++++++++++++++++-----------
1 file changed, 38 insertions(+), 20 deletions(-)
diff --git a/arch/arm/mach-integrator/integrator_ap.c b/arch/arm/mach-integrator/integrator_ap.c
index 7d84080..becba43 100644
--- a/arch/arm/mach-integrator/integrator_ap.c
+++ b/arch/arm/mach-integrator/integrator_ap.c
@@ -62,7 +62,10 @@
#include "common.h"
-/*
+/* Base address to the AP system controller */
+static void __iomem *ap_syscon_base;
+
+/*
* All IO addresses are mapped onto VA 0xFFFx.xxxx, where x.xxxx
* is the (PA >> 12).
*
@@ -70,7 +73,6 @@
* just for now).
*/
#define VA_IC_BASE __io_address(INTEGRATOR_IC_BASE)
-#define VA_SC_BASE __io_address(INTEGRATOR_SC_BASE)
#define VA_EBI_BASE __io_address(INTEGRATOR_EBI_BASE)
#define VA_CMIC_BASE __io_address(INTEGRATOR_HDR_IC)
@@ -99,11 +101,6 @@ static struct map_desc ap_io_desc[] __initdata = {
.length = SZ_4K,
.type = MT_DEVICE
}, {
- .virtual = IO_ADDRESS(INTEGRATOR_SC_BASE),
- .pfn = __phys_to_pfn(INTEGRATOR_SC_BASE),
- .length = SZ_4K,
- .type = MT_DEVICE
- }, {
.virtual = IO_ADDRESS(INTEGRATOR_EBI_BASE),
.pfn = __phys_to_pfn(INTEGRATOR_EBI_BASE),
.length = SZ_4K,
@@ -203,8 +200,6 @@ device_initcall(irq_syscore_init);
/*
* Flash handling.
*/
-#define SC_CTRLC (VA_SC_BASE + INTEGRATOR_SC_CTRLC_OFFSET)
-#define SC_CTRLS (VA_SC_BASE + INTEGRATOR_SC_CTRLS_OFFSET)
#define EBI_CSR1 (VA_EBI_BASE + INTEGRATOR_EBI_CSR1_OFFSET)
#define EBI_LOCK (VA_EBI_BASE + INTEGRATOR_EBI_LOCK_OFFSET)
@@ -212,7 +207,8 @@ static int ap_flash_init(struct platform_device *dev)
{
u32 tmp;
- writel(INTEGRATOR_SC_CTRL_nFLVPPEN | INTEGRATOR_SC_CTRL_nFLWP, SC_CTRLC);
+ writel(INTEGRATOR_SC_CTRL_nFLVPPEN | INTEGRATOR_SC_CTRL_nFLWP,
+ ap_syscon_base + INTEGRATOR_SC_CTRLC_OFFSET);
tmp = readl(EBI_CSR1) | INTEGRATOR_EBI_WRITE_ENABLE;
writel(tmp, EBI_CSR1);
@@ -229,7 +225,8 @@ static void ap_flash_exit(struct platform_device *dev)
{
u32 tmp;
- writel(INTEGRATOR_SC_CTRL_nFLVPPEN | INTEGRATOR_SC_CTRL_nFLWP, SC_CTRLC);
+ writel(INTEGRATOR_SC_CTRL_nFLVPPEN | INTEGRATOR_SC_CTRL_nFLWP,
+ ap_syscon_base + INTEGRATOR_SC_CTRLC_OFFSET);
tmp = readl(EBI_CSR1) & ~INTEGRATOR_EBI_WRITE_ENABLE;
writel(tmp, EBI_CSR1);
@@ -243,9 +240,12 @@ static void ap_flash_exit(struct platform_device *dev)
static void ap_flash_set_vpp(struct platform_device *pdev, int on)
{
- void __iomem *reg = on ? SC_CTRLS : SC_CTRLC;
-
- writel(INTEGRATOR_SC_CTRL_nFLVPPEN, reg);
+ if (on)
+ writel(INTEGRATOR_SC_CTRL_nFLVPPEN,
+ ap_syscon_base + INTEGRATOR_SC_CTRLS_OFFSET);
+ else
+ writel(INTEGRATOR_SC_CTRL_nFLVPPEN,
+ ap_syscon_base + INTEGRATOR_SC_CTRLC_OFFSET);
}
static struct physmap_flash_data ap_flash_data = {
@@ -464,9 +464,6 @@ static struct of_dev_auxdata ap_auxdata_lookup[] __initdata = {
{ /* sentinel */ },
};
-/* Base address to the AP system controller */
-static void __iomem *ap_syscon_base;
-
static void __init ap_init_of(void)
{
unsigned long sc_dec;
@@ -523,7 +520,7 @@ static void __init ap_init_of(void)
of_platform_populate(root, of_default_bus_match_table,
ap_auxdata_lookup, parent);
- sc_dec = readl(VA_SC_BASE + INTEGRATOR_SC_DEC_OFFSET);
+ sc_dec = readl(ap_syscon_base + INTEGRATOR_SC_DEC_OFFSET);
for (i = 0; i < 4; i++) {
struct lm_device *lmdev;
@@ -567,6 +564,27 @@ MACHINE_END
#ifdef CONFIG_ATAGS
/*
+ * For the ATAG boot some static mappings are needed. This will
+ * go away with the ATAG support down the road.
+ */
+
+static struct map_desc ap_io_desc_atag[] __initdata = {
+ {
+ .virtual = IO_ADDRESS(INTEGRATOR_SC_BASE),
+ .pfn = __phys_to_pfn(INTEGRATOR_SC_BASE),
+ .length = SZ_4K,
+ .type = MT_DEVICE
+ },
+};
+
+static void __init ap_map_io_atag(void)
+{
+ iotable_init(ap_io_desc_atag, ARRAY_SIZE(ap_io_desc_atag));
+ ap_syscon_base = __io_address(INTEGRATOR_SC_BASE);
+ ap_map_io();
+}
+
+/*
* This is where non-devicetree initialization code is collected and stashed
* for eventual deletion.
*/
@@ -634,7 +652,7 @@ static void __init ap_init(void)
platform_device_register(&cfi_flash_device);
- sc_dec = readl(VA_SC_BASE + INTEGRATOR_SC_DEC_OFFSET);
+ sc_dec = readl(ap_syscon_base + INTEGRATOR_SC_DEC_OFFSET);
for (i = 0; i < 4; i++) {
struct lm_device *lmdev;
@@ -661,7 +679,7 @@ MACHINE_START(INTEGRATOR, "ARM-Integrator")
/* Maintainer: ARM Ltd/Deep Blue Solutions Ltd */
.atag_offset = 0x100,
.reserve = integrator_reserve,
- .map_io = ap_map_io,
+ .map_io = ap_map_io_atag,
.nr_irqs = NR_IRQS_INTEGRATOR_AP,
.init_early = ap_init_early,
.init_irq = ap_init_irq,
--
1.7.11.7
More information about the linux-arm-kernel
mailing list