[PATCH 10/14] ARM: SPEAr13xx: Remove fields not required for ssp controller
Viresh Kumar
viresh.kumar at linaro.org
Sat Nov 10 23:39:32 EST 2012
From: Shiraz Hashim <shiraz.hashim at st.com>
Few fields are not required to be programmed in platform data of spi controller
now, as it comes via DT. Remove them.
Signed-off-by: Shiraz Hashim <shiraz.hashim at st.com>
Signed-off-by: Viresh Kumar <viresh.kumar at linaro.org>
---
arch/arm/mach-spear13xx/spear1310.c | 2 --
arch/arm/mach-spear13xx/spear13xx.c | 2 --
2 files changed, 4 deletions(-)
diff --git a/arch/arm/mach-spear13xx/spear1310.c b/arch/arm/mach-spear13xx/spear1310.c
index 593a756..451f3b1 100644
--- a/arch/arm/mach-spear13xx/spear1310.c
+++ b/arch/arm/mach-spear13xx/spear1310.c
@@ -34,9 +34,7 @@
/* ssp device registration */
static struct pl022_ssp_controller ssp1_plat_data = {
- .bus_id = 0,
.enable_dma = 0,
- .num_chipselect = 3,
};
/* Add SPEAr1310 auxdata to pass platform data */
diff --git a/arch/arm/mach-spear13xx/spear13xx.c b/arch/arm/mach-spear13xx/spear13xx.c
index 5633d69..c4af775 100644
--- a/arch/arm/mach-spear13xx/spear13xx.c
+++ b/arch/arm/mach-spear13xx/spear13xx.c
@@ -57,12 +57,10 @@ static struct dw_dma_slave ssp_dma_param[] = {
};
struct pl022_ssp_controller pl022_plat_data = {
- .bus_id = 0,
.enable_dma = 1,
.dma_filter = dw_dma_filter,
.dma_rx_param = &ssp_dma_param[1],
.dma_tx_param = &ssp_dma_param[0],
- .num_chipselect = 3,
};
/* CF device registration */
--
1.7.12.rc2.18.g61b472e
More information about the linux-arm-kernel
mailing list