[PATCH v3 02/11] clk: davinci - add PSC clock driver

[Mike Turquette]

Quoting Murali Karicheri (2012-11-05 07:10:52)
> On 11/03/2012 08:07 AM, Sekhar Nori wrote:
> > On 10/25/2012 9:41 PM, Murali Karicheri wrote:
> >> This is the driver for the Power Sleep Controller (PSC) hardware
> >> found on DM SoCs as well Keystone SoCs (c6x). This driver borrowed
> >> code from arch/arm/mach-davinci/psc.c and implemented the driver
> >> as per common clock provider API. The PSC module is responsible for
> >> enabling/disabling the Power Domain and Clock domain for different IPs
> >> present in the SoC. The driver is configured through the clock data
> >> passed to the driver through struct clk_psc_data.
> >>
> >> Signed-off-by: Murali Karicheri <m-karicheri2 at ti.com>
> >> ---
> >> +/**
> >> + * struct clk_psc - DaVinci PSC clock driver data
> >> + *
> >> + * @hw: clk_hw for the psc
> >> + * @psc_data: Driver specific data
> >> + */
> >> +struct clk_psc {
> >> +    struct clk_hw hw;
> >> +    struct clk_psc_data *psc_data;
> >> +    spinlock_t *lock;
> > Unused member? I don't see this being used.
> 
> OK. Will remove.

Those locks are only used for the case where a register might contain
bits for several clocks.  Thus RMW operations are protected.  On OMAP
this isn't necessary due to a very generous register layout (typically
one 32-bit reg per module) controlling clocks.  Seems tha tmaybe this is
not needed for PSC module either?

Regards,
Mike

> >
> > Thanks,
> > Sekhar
> >