[PATCH v3] ARM: zynq: Allow UART1 to be used as DEBUG_LL console.

[Michal Simek]

2012/11/5 Josh Cartwright <josh.cartwright at ni.com>:
> On Mon, Nov 05, 2012 at 04:45:49PM -0500, Nick Bowler wrote:
>> The main UART on the Xilinx ZC702 board is UART1, located at address
>> e0001000.  Add a Kconfig option to select this device as the low-level
>> debugging port.  This allows the really early boot printouts to reach
>> the USB serial adaptor on this board.
>>
>> For consistency's sake, add a choice entry for UART0 even though it is
>> the the default if UART1 is not selected.
>>
>> Signed-off-by: Nick Bowler <nbowler at elliptictech.com>
>> Tested-by: Josh Cartwright <josh.cartwright at ni.com>
>> ---
>> Sorry all for the phenominal delay in sending this out.  Josh, I kept
>> your Tested-By since this version is Obviously Equivalent??? to v2...
>
> I re-tested again just in case and everything is good.


Thanks guys, Applied.

Michal