[PATCH V2 2/3] ARM: dts: omap5: EMIF device tree data for OMAP5 boards

[Benoit Cousson]

On 10/11/2012 02:47 PM, Lokesh Vutla wrote:
> Adding EMIF device tree data for OMAP5 boards.
> 
> Signed-off-by: Lokesh Vutla <lokeshvutla at ti.com>
> ---
>  arch/arm/boot/dts/omap5.dtsi |   24 ++++++++++++++++++++++++
>  1 file changed, 24 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/omap5.dtsi b/arch/arm/boot/dts/omap5.dtsi
> index 5db33f4..445aeea 100644
> --- a/arch/arm/boot/dts/omap5.dtsi
> +++ b/arch/arm/boot/dts/omap5.dtsi
> @@ -319,5 +319,29 @@
>  			ti,buffer-size = <128>;
>  			ti,hwmods = "mcbsp3";
>  		};
> +
> +		emif1: emif at 0x4c000000 {
> +			compatible	= "ti,emif-4d5";
> +			ti,hwmods	= "emif1";
> +			phy-type	= <2>;
> +			reg = <0x4c000000 0x3ff>;

Should 0x400. This parameter is the size, not the end address.

> +			interrupts = <0 110 0x4>;
> +			interrupt-parent = <&gic>;

Please remove the interrupt-parent. It is not needed since DT will use
the parent node to get it. It will avoid duplicating the entry for every
nodes.

> +			hw-caps-read-idle-ctrl;
> +			hw-caps-ll-interface;
> +			hw-caps-temp-alert;
> +		};
> +
> +		emif2: emif at 0x4d000000 {
> +			compatible	= "ti,emif-4d5";
> +			ti,hwmods	= "emif2";
> +			phy-type	= <2>;

Can you just add a comment to give more information. I know this is in
the binding documentation, but some more comment never hurt.

> +			reg = <0x4d000000 0x3ff>;

0x400 as well.

> +			interrupts = <0 111 0x4>;
> +			interrupt-parent = <&gic>;

Ditto.

> +			hw-caps-read-idle-ctrl;
> +			hw-caps-ll-interface;
> +			hw-caps-temp-alert;
> +		};
>  	};
>  };
> 

Regards,
Benoit