[PATCHv2 1/7] i2c: omap: Fix the revision register read

[Shubhrajyoti]

On Monday 05 November 2012 01:20 PM, Felipe Balbi wrote:
> Hi,
>
> On Sun, Nov 04, 2012 at 04:14:27PM +0530, Shubhrajyoti D wrote:
>> The revision register on OMAP4 is a 16-bit lo and a 16-bit
>> hi. Currently the driver reads only the lower 8-bits.
>> Fix the same by preventing the truncating of the rev register
>> for OMAP4.
>>
>> Also use the scheme bit ie bit-14 of the hi register to know if it
>> is OMAP_I2C_IP_VERSION_2.
>>
>> On platforms previous to OMAP4 the offset 0x04 is IE register whose
>> bit-14 reset value is 0, the code uses the same to its advantage.
>>
>> Also since the omap_i2c_read_reg uses reg_map_ip_* a raw_readw is done
>> to fetch the revision register.
>>
>> The dev->regs is populated after reading the rev_hi. A NULL check
>> has been added in the resume handler to prevent the access before
>> the setting of the regs.
>>
>> Signed-off-by: Shubhrajyoti D <shubhrajyoti at ti.com>
>> ---
>>  drivers/i2c/busses/i2c-omap.c |   61 ++++++++++++++++++++++++++++++++---------
>>  1 files changed, 48 insertions(+), 13 deletions(-)
>>
>> diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c
>> index db31eae..72fce6d 100644
>> --- a/drivers/i2c/busses/i2c-omap.c
>> +++ b/drivers/i2c/busses/i2c-omap.c
>> @@ -49,9 +49,10 @@
>>  #define OMAP_I2C_OMAP1_REV_2		0x20
>>  
>>  /* I2C controller revisions present on specific hardware */
>> -#define OMAP_I2C_REV_ON_2430		0x36
>> -#define OMAP_I2C_REV_ON_3430_3530	0x3C
>> -#define OMAP_I2C_REV_ON_3630_4430	0x40
>> +#define OMAP_I2C_REV_ON_2430		0x00000036
>> +#define OMAP_I2C_REV_ON_3430_3530	0x0000003C
>> +#define OMAP_I2C_REV_ON_3630		0x00000040
>> +#define OMAP_I2C_REV_ON_4430_PLUS	0x50400002
>>  
>>  /* timeout waiting for the controller to respond */
>>  #define OMAP_I2C_TIMEOUT (msecs_to_jiffies(1000))
>> @@ -202,7 +203,7 @@ struct omap_i2c_dev {
>>  						 * fifo_size==0 implies no fifo
>>  						 * if set, should be trsh+1
>>  						 */
>> -	u8			rev;
>> +	u32			rev;
>>  	unsigned		b_hw:1;		/* bad h/w fixes */
>>  	unsigned		receiver:1;	/* true when we're in receiver mode */
>>  	u16			iestate;	/* Saved interrupt register */
>> @@ -490,7 +491,7 @@ static void omap_i2c_resize_fifo(struct omap_i2c_dev *dev, u8 size, bool is_rx)
>>  
>>  	omap_i2c_write_reg(dev, OMAP_I2C_BUF_REG, buf);
>>  
>> -	if (dev->rev < OMAP_I2C_REV_ON_3630_4430)
>> +	if (dev->rev < OMAP_I2C_REV_ON_3630)
>>  		dev->b_hw = 1; /* Enable hardware fixes */
>>  
>>  	/* calculate wakeup latency constraint for MPU */
>> @@ -1052,6 +1053,16 @@ static const struct of_device_id omap_i2c_of_match[] = {
>>  MODULE_DEVICE_TABLE(of, omap_i2c_of_match);
>>  #endif
>>  
>> +#define OMAP_I2C_SCHEME(rev)		((rev & 0xc000) >> 14)
>> +
>> +#define OMAP_I2C_REV_SCHEME_0_MAJOR(rev) (rev >> 4)
>> +#define OMAP_I2C_REV_SCHEME_0_MINOR(rev) (rev & 0xf)
>> +
>> +#define OMAP_I2C_REV_SCHEME_1_MAJOR(rev) ((rev & 0x0700) >> 7)
>> +#define OMAP_I2C_REV_SCHEME_1_MINOR(rev) (rev & 0x1f)
>> +#define OMAP_I2C_SCHEME_0		0
>> +#define OMAP_I2C_SCHEME_1		1
>> +
>>  static int __devinit
>>  omap_i2c_probe(struct platform_device *pdev)
>>  {
>> @@ -1064,6 +1075,8 @@ omap_i2c_probe(struct platform_device *pdev)
>>  	const struct of_device_id *match;
>>  	int irq;
>>  	int r;
>> +	u32 rev;
>> +	u16 minor, major;
>>  
>>  	/* NOTE: driver uses the static register mapping */
>>  	mem = platform_get_resource(pdev, IORESOURCE_MEM, 0);
>> @@ -1117,11 +1130,6 @@ omap_i2c_probe(struct platform_device *pdev)
>>  
>>  	dev->reg_shift = (dev->flags >> OMAP_I2C_FLAG_BUS_SHIFT__SHIFT) & 3;
>>  
>> -	if (dev->dtrev == OMAP_I2C_IP_VERSION_2)
>> -		dev->regs = (u8 *)reg_map_ip_v2;
>> -	else
>> -		dev->regs = (u8 *)reg_map_ip_v1;
>> -
>>  	pm_runtime_enable(dev->dev);
>>  	pm_runtime_set_autosuspend_delay(dev->dev, OMAP_I2C_PM_TIMEOUT);
>>  	pm_runtime_use_autosuspend(dev->dev);
>> @@ -1130,7 +1138,31 @@ omap_i2c_probe(struct platform_device *pdev)
>>  	if (IS_ERR_VALUE(r))
>>  		goto err_free_mem;
>>  
>> -	dev->rev = omap_i2c_read_reg(dev, OMAP_I2C_REV_REG) & 0xff;
>> +	/*
>> +	 * Read the Rev hi bit-[15:14] ie scheme this is 1 indicates ver2.
>> +	 * On omap3 Offset 4 is IE Reg the bit [15:14] is XDR_IE which is 0
> comment is wrong. You talk about 2 bits and document only one of them.
> Also, this is valid for all OMAPs until OMAP3, comment should probably
> read: On OMAP1/2/3 offset 0x04 is.....
will fix the comment.
>
>> +	 * at reset. Also since the omap_i2c_read_reg uses reg_map_ip_* a
>> +	 * raw_readw is done.
>> +	 */
>> +	rev = __raw_readw(dev->base + 0x04);
>> +
>> +	switch (OMAP_I2C_SCHEME(rev)) {
>> +	case OMAP_I2C_SCHEME_0:
>> +		dev->regs = (u8 *)reg_map_ip_v1;
>> +		dev->rev = omap_i2c_read_reg(dev, OMAP_I2C_REV_REG) & 0xff;
> drop the 0xff. Top byte is supposed to be zero 
yes.

> and if it's not, we want
> to know what they hold.
OK. Just thought that the reserved values can wiped off:-)
>
>> +		minor = OMAP_I2C_REV_SCHEME_0_MAJOR(dev->rev);
>> +		major = OMAP_I2C_REV_SCHEME_0_MAJOR(dev->rev);
>> +		break;
>> +	case OMAP_I2C_SCHEME_1:
>> +		/* FALLTHROUGH */
>> +	default:
>> +		dev->regs = (u8 *)reg_map_ip_v2;
>> +		rev = (rev << 16) |
>> +			omap_i2c_read_reg(dev, OMAP_I2C_IP_V2_REVNB_LO);
>> +		minor = OMAP_I2C_REV_SCHEME_1_MINOR(rev);
>> +		major = OMAP_I2C_REV_SCHEME_1_MAJOR(rev);
>> +		dev->rev = rev;
>> +	}
>>  
>>  	dev->errata = 0;
>>  
>> @@ -1155,7 +1187,7 @@ omap_i2c_probe(struct platform_device *pdev)
>>  
>>  		dev->fifo_size = (dev->fifo_size / 2);
>>  
>> -		if (dev->rev < OMAP_I2C_REV_ON_3630_4430)
>> +		if (dev->rev < OMAP_I2C_REV_ON_3630)
>>  			dev->b_hw = 1; /* Enable hardware fixes */
> looks like this was applicable to 4430 too, what happened ?
No actually this can be deleted completely once the
start -> transaction -> stop sequence recommendation is followed.
>