[RFC PATCH 11/11] ARM: DT: Add support to system control module for OMAP4

[Konstantin Baydarov]

On 05/30/2012 12:38 PM, Cousson, Benoit wrote:
> On 5/29/2012 11:49 AM, Konstantin Baydarov wrote:
>>    Hi, Eduardo.
>>
>> On 05/25/2012 12:26 PM, Eduardo Valentin wrote:
>>> This patch add device tree entries on OMAP4 based boards
>>> for System Control Module (SCM).
>>>
>>> Signed-off-by: Eduardo Valentin<eduardo.valentin at ti.com>
>>> ---
>>>   arch/arm/boot/dts/omap4.dtsi |   13 +++++++++++++
>>>   1 files changed, 13 insertions(+), 0 deletions(-)
>>>
>>> diff --git a/arch/arm/boot/dts/omap4.dtsi b/arch/arm/boot/dts/omap4.dtsi
>>> index 359c497..d2cb392 100644
>>> --- a/arch/arm/boot/dts/omap4.dtsi
>>> +++ b/arch/arm/boot/dts/omap4.dtsi
>>> @@ -272,5 +272,18 @@
>>>               ti,hwmods = "mmc5";
>>>               ti,needs-special-reset;
>>>           };
>>> +
>>> +        ctrl_module_core: ctrl_module_core at 4a002000 {
>>> +            compatible = "ti,omap4-control";
>>> +            ti,hwmods = "ctrl_module_core";
>>> +            bandgap {
>>> +                compatible = "ti,omap4460-bandgap";
>>> +                interrupts =<0 126 4>; /* talert */
>>> +                ti,tshut-gpio =<86>; /* tshut */
>>> +            };
>> I believe that CPU-specific bandgap definition should be moved to bard specific dts.
>
> Mmm, why, since it is CPU specific and not board specific. I has to be in the SoC file.
Speaking about omap4430 - omap4430 bandgap differs from omap4460, so if omap4430 bandgap support will be added to omap-bandgap driver the version of bandgap should specified in dts file. omap4.dtsi is a common for omap4 boards, that is why I'm suggesting to move bandgap description to probably board specific file.
Another solution is to determine bandgap type in driver probe function, but in that case "ti,omap4460-bandgap" in omap4.dtsi should be replaced to "ti,omap4-bandgap".

  BR,
    Konstantin Baydarov.

> Regards,
> Benoit