[PATCH 15/16] ARM: ux500: Add regulator support for nomadik-i2c into the db8500 Device Tree

[Lee Jones]

On 29/05/12 09:53, Linus Walleij wrote:
> On Tue, May 22, 2012 at 4:00 PM, Lee Jones<lee.jones at linaro.org>  wrote:
>
>> This doesn't change the behavior of the current system, only DT:s it.
>>
>> It's just that:
>>
>>> struct regulator_consumer_supply db8500_vape_consumers[] = {
>>>         REGULATOR_SUPPLY("v-i2c", "nmk-i2c.0")
>>
>> In drivers/mfd/db8500-prcmu.c is replaced by:
>>
>>> v-i2c-supply =<&db8500_vape_reg>;
>>
>> In the Device Tree
>
> Yes...
>
>> If we want to start re-working things, can we do it after the DT enablement
>> please?
>
> I'm told not to put DT bindings for things in place if they are
> incorrect, since they get set in stone... and I'm told we should
> probably remove this one regulator from the device rather.
> I'm just uncertain.

Nothing is set in stone. I'm always happy to do clean-ups and code 
corrections. :)

Mark,

What's the answer?

Kind regards,
Lee

-- 
Lee Jones
Linaro ST-Ericsson Landing Team Lead
M: +44 77 88 633 515
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog