[PATCH v7 0/3] Add PMECC support for at91 nand flash driver

[Josh Wu]

Hi, Artem

On 5/16/2012 5:17 PM, Artem Bityutskiy wrote:
> On Tue, 2012-05-15 at 22:47 +0800, Josh Wu wrote:
>> Changes since v6,
>> 	split into 3 patches.
>> 	remove of_flat_dt_is_compatible() function. use additional dt parameter "has-pmecc".
>> 	refine the error handling code.
>> 	refine original atmel_nand_init_params() function.
>>
>> Changes since v5,
>> 	add has_pmecc field to replace cpu_has_pmecc() function. Use compatible check in when proble.
>> 	simplify the pmecc_get_ecc_bytes() function.
>>
>> Changes since v4,
>> 	fix typo and checkpatch warnings.
>> 	fix according to JC's suggestion. replace cpu_is_xxx() with DT
>> 	modify dt binding atmel nand document to add pmecc support.
>> 	tested in sam9263 without break hw ecc.
>> 	add ecc.strength.
> Hi,
>
> Aiaiai identified the following issues with your patch-set - could you
> please take a look?

sure.

>
> --------------------------------------------------------------------------------
>
> Successfully built configuration "arm-at91cap9_defconfig,arm,arm-unknown-linux-gnueabi-", results:
>
> --- before_patching.log
> +++ after_patching.log
> @@ @@
> +drivers/mtd/nand/atmel_nand.c: In function 'atmel_pmecc_nand_init_params':
> +drivers/mtd/nand/atmel_nand.c:910:29: warning: assignment from incompatible pointer type [enabled by default]
> +drivers/mtd/nand/atmel_nand.c:910:50: warning: incorrect type in assignment (different argument counts) [sparse]
> +drivers/mtd/nand/atmel_nand.c:910:50:    expected int ( *read_page )( ... ) [sparse]
> +drivers/mtd/nand/atmel_nand.c:910:50:    got int ( static [toplevel] *<noident>  )( ... ) [sparse]
> +drivers/mtd/nand/atmel_nand.c:912:30: warning: assignment from incompatible pointer type [enabled by default]
> +drivers/mtd/nand/atmel_nand.c:912:51: warning: incorrect type in assignment (different argument counts) [sparse]
> +drivers/mtd/nand/atmel_nand.c:912:51:    expected void ( *write_page )( ... ) [sparse]
> +drivers/mtd/nand/atmel_nand.c:912:51:    got void ( static [toplevel] *<noident>  )( ... ) [sparse]
>
> --------------------------------------------------------------------------------

Since I used Code Sourcery tools-chain (2010q1-202) to compile the code 
and I didn't get any warning.

So I am not sure what's caused above warnings. From the warning message, 
I don't know the reason exactly.

I just checked the PMECC read/write functions definition in my patch

+static int atmel_nand_pmecc_read_page(struct mtd_info *mtd,
+		struct nand_chip *chip, uint8_t *buf, int32_t page)

+static void atmel_nand_pmecc_write_page(struct mtd_info *mtd,
+		struct nand_chip *chip, const uint8_t *buf)


compare with the original HW read function (no write function)

static int atmel_nand_read_page(struct mtd_info *mtd,
		struct nand_chip *chip, uint8_t *buf, int page)


The only difference is int32_t, and I don't think the warning is caused 
by this int32_t.

Could you have any ideas to fix such warning? That should be very 
helpful for me.

>
> checkpatch.pl has some complaints:
>
> --------------------------------------------------------------------------------
>
> checkpatch.pl results for patch "[PATCH 3/3] MTD: atmel_nand: Update driver to support Programmable  Multibit ECC controller"
>
> WARNING:LONG_LINE: line over 80 characters
> #60: FILE: drivers/mtd/nand/atmel_nand.c:115:
> +       int16_t                 smu[AT_NB_ERROR_MAX + 2][2 * AT_NB_ERROR_MAX + 1];
>
> WARNING:LONG_LINE: line over 80 characters
> #326: FILE: drivers/mtd/nand/atmel_nand.c:567:
> +                               a = readw_relaxed(alpha_to + tmp % host->cw_len);
>
> WARNING:LONG_LINE: line over 80 characters
> #348: FILE: drivers/mtd/nand/atmel_nand.c:589:
> +                               a = readw_relaxed(index_of + host->smu[i + 1][k]);
>
> total: 0 errors, 3 warnings, 879 lines checked
>
> --------------------------------------------------------------------------------
>
> checkpatch.pl results for the entire squashed patch-set
>
> WARNING:LONG_LINE: line over 80 characters
> #376: FILE: drivers/mtd/nand/atmel_nand.c:115:
> +       int16_t                 smu[AT_NB_ERROR_MAX + 2][2 * AT_NB_ERROR_MAX + 1];

I'll fix it.

>
> WARNING:LONG_LINE: line over 80 characters
> #642: FILE: drivers/mtd/nand/atmel_nand.c:567:
> +                               a = readw_relaxed(alpha_to + tmp % host->cw_len);
>
> WARNING:LONG_LINE: line over 80 characters
> #664: FILE: drivers/mtd/nand/atmel_nand.c:589:
> +                               a = readw_relaxed(index_of + host->smu[i + 1][k]);
>
> total: 0 errors, 3 warnings, 1136 lines checked

For these two warnings, I would like to keep it for more readable. but 
if you would like to fix the warning, then I can fix them too by split 
into two lines.

> --------------------------------------------------------------------------------
>
Thanks
Best Regards,
Josh Wu