[PATCH 14/15] drivers/regulators: Enable the ab8500 for Device Tree

[Arnd Bergmann]

On Tuesday 08 May 2012, Lee Jones wrote:
> This piece of code plucks pre-defined initialisation values and from the 
> Device Tree and uses them to set-up regulator related registers on the 
> u8500. See 'struct ab8500_regulator_reg_init ab8500_regulator_reg_init' 
> in arch/arm/mach-ux500/board-mop500-regulators.c for reference.
> 
> I did run this past Arnd before writing the code and he agreed that this 
> would be suitable; however, if you know of a better way in which I can 
> do this, I'd be pleased to hear of it.

It was the best approach that I could think of for this, but I'm also
a total newbie on regulators.

	Arnd