[PATCH 01/10] mmc: mxs-mmc: use global stmp_device functionality
Marek Vasut
marex at denx.de
Mon May 7 19:41:22 EDT 2012
Dear Shawn Guo,
> Use global stmp_device functionality to reduce mach-dependency.
>
> Signed-off-by: Shawn Guo <shawn.guo at linaro.org>
Acked-by: Marek Vasut <marex at denx.de>
> ---
> drivers/mmc/host/mxs-mmc.c | 14 +++++++-------
> 1 files changed, 7 insertions(+), 7 deletions(-)
>
> diff --git a/drivers/mmc/host/mxs-mmc.c b/drivers/mmc/host/mxs-mmc.c
> index bb03ddd..2ea5361 100644
> --- a/drivers/mmc/host/mxs-mmc.c
> +++ b/drivers/mmc/host/mxs-mmc.c
> @@ -40,9 +40,9 @@
> #include <linux/module.h>
> #include <linux/fsl/mxs-dma.h>
> #include <linux/pinctrl/consumer.h>
> +#include <linux/stmp_device.h>
>
> #include <mach/mxs.h>
> -#include <mach/common.h>
> #include <mach/mmc.h>
>
> #define DRIVER_NAME "mxs-mmc"
> @@ -191,7 +191,7 @@ static void mxs_mmc_reset(struct mxs_mmc_host *host)
> {
> u32 ctrl0, ctrl1;
>
> - mxs_reset_block(host->base);
> + stmp_reset_block(host->base);
>
> ctrl0 = BM_SSP_CTRL0_IGNORE_CRC;
> ctrl1 = BF_SSP(0x3, CTRL1_SSP_MODE) |
> @@ -279,7 +279,7 @@ static irqreturn_t mxs_mmc_irq_handler(int irq, void
> *dev_id)
>
> stat = readl(host->base + HW_SSP_CTRL1);
> writel(stat & MXS_MMC_IRQ_BITS,
> - host->base + HW_SSP_CTRL1 + MXS_CLR_ADDR);
> + host->base + HW_SSP_CTRL1 + STMP_OFFSET_REG_CLR);
>
> if ((stat & BM_SSP_CTRL1_SDIO_IRQ) && (stat & BM_SSP_CTRL1_SDIO_IRQ_EN))
> mmc_signal_sdio_irq(host->mmc);
> @@ -637,18 +637,18 @@ static void mxs_mmc_enable_sdio_irq(struct mmc_host
> *mmc, int enable)
>
> if (enable) {
> writel(BM_SSP_CTRL0_SDIO_IRQ_CHECK,
> - host->base + HW_SSP_CTRL0 + MXS_SET_ADDR);
> + host->base + HW_SSP_CTRL0 + STMP_OFFSET_REG_SET);
> writel(BM_SSP_CTRL1_SDIO_IRQ_EN,
> - host->base + HW_SSP_CTRL1 + MXS_SET_ADDR);
> + host->base + HW_SSP_CTRL1 + STMP_OFFSET_REG_SET);
>
> if (readl(host->base + HW_SSP_STATUS) & BM_SSP_STATUS_SDIO_IRQ)
> mmc_signal_sdio_irq(host->mmc);
>
> } else {
> writel(BM_SSP_CTRL0_SDIO_IRQ_CHECK,
> - host->base + HW_SSP_CTRL0 + MXS_CLR_ADDR);
> + host->base + HW_SSP_CTRL0 + STMP_OFFSET_REG_CLR);
> writel(BM_SSP_CTRL1_SDIO_IRQ_EN,
> - host->base + HW_SSP_CTRL1 + MXS_CLR_ADDR);
> + host->base + HW_SSP_CTRL1 + STMP_OFFSET_REG_CLR);
> }
>
> spin_unlock_irqrestore(&host->lock, flags);
Best regards,
Marek Vasut
More information about the linux-arm-kernel
mailing list