[PATCH v4 06/39] ARM: OMAP2+: onenand: return value in init function

[Sergei Shtylyov]

Hello.

On 01-05-2012 16:20, Afzal Mohammed wrote:

> Modify board_onenand_init to return platform data. This
> would be required for boards to be able to pass it to
> gpmc driver so that it finally reaches onenand driver.

> Also un-static the function so that boards can use it.

> Signed-off-by: Afzal Mohammed<afzal at ti.com>
[...]

> diff --git a/arch/arm/mach-omap2/board-flash.h b/arch/arm/mach-omap2/board-flash.h
> index 052964c..75ba49f 100644
> --- a/arch/arm/mach-omap2/board-flash.h
> +++ b/arch/arm/mach-omap2/board-flash.h
> @@ -52,3 +52,15 @@ board_nand_init(struct mtd_partition *nand_parts,
>   	return NULL;
>   }
>   #endif
> +
> +#if defined(CONFIG_MTD_ONENAND_OMAP2) || \
> +		defined(CONFIG_MTD_ONENAND_OMAP2_MODULE)

    You can use IS_ENABLED(CONFIG_MTD_ONENAND_OMAP2) instead these two.

> +extern struct omap_onenand_platform_data * __init
> +board_onenand_init(struct mtd_partition *onenand_parts, u8 nr_parts, u8 cs);
> +#else
> +static inline struct omap_onenand_platform_data *
> +__init board_onenand_init(struct mtd_partition *nor_parts, u8 nr_parts, u8 cs)
> +{
> +	return NULL;
> +}
> +#endif

WBR, Sergei