[PATCH 08/12] gpio/twl: Allocate irq_desc dynamically for SPARSE_IRQ support

[Grant Likely]

On Wed, 7 Mar 2012 13:57:05 +0100, "Cousson, Benoit" <b-cousson at ti.com> wrote:
> Hi Grant,
> 
> That fix is tightly coupled with the previous twl4030-irq change, so it 
> will be good to pulled it with the twl series through MFD if you are OK 
> with that?
> 
> Care to ack this one and the next one?
> 
> Thanks,
> Benoit
> 
> 
> On 3/2/2012 5:50 PM, Benoit Cousson wrote:
> > Do not use the board pdata for irq_base, but allocate them dynamically
> > to allow a proper support of SPARSE_IRQ.
> >
> > Fix an unneeded line wrap.
> >
> > Signed-off-by: Benoit Cousson<b-cousson at ti.com>
> > Acked-by: Felipe Balbi<balbi at ti.com>

Acked-by: Grant Likely <grant.likely at secretlab.ca>

> > ---
> >   drivers/gpio/gpio-twl4030.c |   33 +++++++++++++++++----------------
> >   1 files changed, 17 insertions(+), 16 deletions(-)
> >
> > diff --git a/drivers/gpio/gpio-twl4030.c b/drivers/gpio/gpio-twl4030.c
> > index 697396c..49e5c6e 100644
> > --- a/drivers/gpio/gpio-twl4030.c
> > +++ b/drivers/gpio/gpio-twl4030.c
> > @@ -395,23 +395,26 @@ static int gpio_twl4030_remove(struct platform_device *pdev);
> >   static int __devinit gpio_twl4030_probe(struct platform_device *pdev)
> >   {
> >   	struct twl4030_gpio_platform_data *pdata = pdev->dev.platform_data;
> > -	int ret;
> > +	int ret, irq_base;
> >
> >   	/* maybe setup IRQs */
> > -	if (pdata->irq_base) {
> > -		if (is_module()) {
> > -			dev_err(&pdev->dev,
> > -				"can't dispatch IRQs from modules\n");
> > -			goto no_irqs;
> > -		}
> > -		ret = twl4030_sih_setup(&pdev->dev, TWL4030_MODULE_GPIO,
> > -					pdata->irq_base);
> > -		if (ret<  0)
> > -			return ret;
> > -		WARN_ON(ret != pdata->irq_base);
> > -		twl4030_gpio_irq_base = ret;
> > +	if (is_module()) {
> > +		dev_err(&pdev->dev, "can't dispatch IRQs from modules\n");
> > +		goto no_irqs;
> > +	}
> > +
> > +	irq_base = irq_alloc_descs(-1, 0, TWL4030_GPIO_MAX, 0);
> > +	if (irq_base<  0) {
> > +		dev_err(&pdev->dev, "Failed to alloc irq_descs\n");
> > +		return irq_base;
> >   	}
> >
> > +	ret = twl4030_sih_setup(&pdev->dev, TWL4030_MODULE_GPIO, irq_base);
> > +	if (ret<  0)
> > +		return ret;
> > +
> > +	twl4030_gpio_irq_base = irq_base;
> > +
> >   no_irqs:
> >   	/*
> >   	 * NOTE:  boards may waste power if they don't set pullups
> > @@ -443,9 +446,7 @@ no_irqs:
> >
> >   	ret = gpiochip_add(&twl_gpiochip);
> >   	if (ret<  0) {
> > -		dev_err(&pdev->dev,
> > -				"could not register gpiochip, %d\n",
> > -				ret);
> > +		dev_err(&pdev->dev, "could not register gpiochip, %d\n", ret);
> >   		twl_gpiochip.ngpio = 0;
> >   		gpio_twl4030_remove(pdev);
> >   	} else if (pdata->setup) {
> 

-- 
Grant Likely, B.Sc, P.Eng.
Secret Lab Technologies,Ltd.