[PATCH v2 0/6] mmc: omap_hsmmc: Clean up use/abuse of pdev->id

[Rajendra Nayak]

On Friday 24 February 2012 03:40 PM, Rajendra Nayak wrote:
> Chris,
>
> On Thursday 23 February 2012 04:56 PM, Rajendra Nayak wrote:
>> Re-sending as these patches did not make it to the lists due to
>> issues with my 'git send-email'
>>
>> This series mainly cleans up all instances of hardcoding's in
>> the driver based on pdev->id. This is cleanup leading to the
>> DT adaptation of omap_hsmmc driver.
>>
>> v2 mainly has some minor changes to get rid of a debug print
>> which was still using host->id and getting rid of 'id' field
>> entirely from omap_hsmmc_host struct.
>>
>> The series is tested on OMAP4SDP, OMAP4panda, OMAP3beagle and OMAP2430SDP
>> boards.
>
> This series is reviewed/tested and acked by Balaji and Venkat.
> Care to pull this in for 3.4?
>
> I have one other cleanup patch on top of this series to make all
> remaining pr_* prints in the driver to dev_* [1].
> It would be great if you could pick that up as well.
>
> These patches are cleanups leading to the DT conversion of omap_hsmmc
> driver.

Chris, Ping. I am basing my DT support patches on top of these cleanups.
Would be great if you can have a look and pull them in.

>
> regards,
> Rajendra
>
> [1] http://marc.info/?l=linux-mmc&m=132999677405098&w=3
>
>>
>> regards,
>> Rajendra
>>
>> Balaji T K (3):
>> mmc: omap_hsmmc: use platform_get_resource_byname for tx/rx DMA
>> channels
>> mmc: omap_hsmmc: remove unused .set_sleep function
>> mmc: omap_hsmmc: Use OMAP_HSMMC_SUPPORTS_DUAL_VOLT flag to remove
>> host->id based hardcoding
>>
>> Rajendra Nayak (3):
>> mmc: omap_hsmmc: Get rid of omap_hsmmc_1_set_power function
>> mmc: omap_hsmmc: Get rid of omap_hsmmc_4_set_power function
>> mmc: omap_hsmmc: Don't expect MMC1 to always have vmmc supply
>>
>> arch/arm/plat-omap/include/plat/mmc.h | 2 -
>> drivers/mmc/host/omap_hsmmc.c | 175 +++------------------------------
>> 2 files changed, 16 insertions(+), 161 deletions(-)
>>
>