[PATCH v3 2/5] ARM: tegra: select CPU_FREQ_TABLE

[Alan Ott]

From: Arnd Bergmann <arnd at arndb.de>

The tegra cpufreq implementation relies on the cpu_freq_table
code, so make sure that this is always there when needed.

Signed-off-by: Arnd Bergmann <arnd at arndb.de>
Signed-off-by: Alan Ott <alan at signal11.us>
---
 arch/arm/mach-tegra/Kconfig |    2 ++
 1 files changed, 2 insertions(+), 0 deletions(-)

diff --git a/arch/arm/mach-tegra/Kconfig b/arch/arm/mach-tegra/Kconfig
index 373652d..60f3e4b 100644
--- a/arch/arm/mach-tegra/Kconfig
+++ b/arch/arm/mach-tegra/Kconfig
@@ -10,6 +10,7 @@ config ARCH_TEGRA_2x_SOC
 	select USB_ARCH_HAS_EHCI if USB_SUPPORT
 	select USB_ULPI if USB_SUPPORT
 	select USB_ULPI_VIEWPORT if USB_SUPPORT
+	select CPU_FREQ_TABLE if CPU_FREQ
 	help
 	  Support for NVIDIA Tegra AP20 and T20 processors, based on the
 	  ARM CortexA9MP CPU and the ARM PL310 L2 cache controller
@@ -23,6 +24,7 @@ config ARCH_TEGRA_3x_SOC
 	select USB_ULPI if USB_SUPPORT
 	select USB_ULPI_VIEWPORT if USB_SUPPORT
 	select USE_OF
+	select CPU_FREQ_TABLE if CPU_FREQ
 	help
 	  Support for NVIDIA Tegra T30 processor family, based on the
 	  ARM CortexA9MP CPU and the ARM PL310 L2 cache controller
-- 
1.7.0.4