[PATCH 3/3 v3] spi/atmel: add DT support
Jean-Christophe PLAGNIOL-VILLARD
plagnioj at jcrosoft.com
Fri Mar 2 05:03:07 EST 2012
The atmel_spi use only gpio for chip select.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
Cc: devicetree-discuss at lists.ozlabs.org
Cc: spi-devel-general at lists.sourceforge.net
---
.../devicetree/bindings/spi/spi_atmel.txt | 6 ++++++
drivers/spi/spi-atmel.c | 12 +++++++++++-
2 files changed, 17 insertions(+), 1 deletions(-)
create mode 100644 Documentation/devicetree/bindings/spi/spi_atmel.txt
diff --git a/Documentation/devicetree/bindings/spi/spi_atmel.txt b/Documentation/devicetree/bindings/spi/spi_atmel.txt
new file mode 100644
index 0000000..7ec3d8d
--- /dev/null
+++ b/Documentation/devicetree/bindings/spi/spi_atmel.txt
@@ -0,0 +1,6 @@
+Atmel SPI device
+
+Required properties:
+- compatible : should be "atmel,at91rm9200-spi".
+- reg: Address and length of the register set for the device
+- interrupts: Should contain macb interrupt
diff --git a/drivers/spi/spi-atmel.c b/drivers/spi/spi-atmel.c
index 16d6a83..7bcd11f 100644
--- a/drivers/spi/spi-atmel.c
+++ b/drivers/spi/spi-atmel.c
@@ -19,6 +19,7 @@
#include <linux/interrupt.h>
#include <linux/spi/spi.h>
#include <linux/slab.h>
+#include <linux/of.h>
#include <asm/io.h>
#include <mach/board.h>
@@ -938,7 +939,7 @@ static int __devinit atmel_spi_probe(struct platform_device *pdev)
master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH;
master->bus_num = pdev->id;
- master->num_chipselect = 4;
+ master->num_chipselect = master->dev.of_node ? 0 : 4;
master->setup = atmel_spi_setup;
master->transfer = atmel_spi_transfer;
master->cleanup = atmel_spi_cleanup;
@@ -1064,11 +1065,20 @@ static int atmel_spi_resume(struct platform_device *pdev)
#define atmel_spi_resume NULL
#endif
+#if defined(CONFIG_OF)
+static const struct of_device_id atmel_spi_dt_ids[] = {
+ { .compatible = "atmel,at91rm9200-spi" },
+ { /* sentinel */ }
+};
+
+MODULE_DEVICE_TABLE(of, atmel_spi_dt_ids);
+#endif
static struct platform_driver atmel_spi_driver = {
.driver = {
.name = "atmel_spi",
.owner = THIS_MODULE,
+ .of_match_table = of_match_ptr(atmel_spi_dt_ids),
},
.suspend = atmel_spi_suspend,
.resume = atmel_spi_resume,
--
1.7.7
More information about the linux-arm-kernel
mailing list