[PATCH V2] ARM: dt: tegra: paz00: add regulators
swarren at wwwdotorg.org
Wed Jun 27 13:08:14 EDT 2012
On 06/27/2012 05:31 AM, Mark Brown wrote:
> On Tue, Jun 26, 2012 at 06:31:00PM -0600, Stephen Warren wrote:
>> sm1: HW defaults and schematic match at 1.0v. marvin24's kernel had a max
>> of 1.125v, but this wasn't applied since apply_uV wasn't set.
> apply_uV is only valid if a single voltage is specified. If a voltage
> range were specified and it were acted on we'd take the lowest (not
> highest) voltage allowed.
Ah right. When I apply this, I'll reword that to something more like:
sm1: HW defaults and schematic match at 1.0v. marvin24's kernel had a
max of 1.125v, but this higher voltage was only applied to HW by DVFS
code, which isn't currently supported in mainline.
More information about the linux-arm-kernel