[PATCH 1/2 V3] MXS: Set I2C timing registers for mxs-i2c

[Marek Vasut]

Dear Shawn Guo,

> On Sat, Jun 23, 2012 at 08:47:32PM +0200, Marek Vasut wrote:
> > Dear Shawn Guo,
> > 
> > > This patch configures the I2C bus timing registers according
> > > to information passed via DT. Currently, 100kHz and 400kHz
> > > modes are supported.
> > 
> > [...]
> > 
> > Is there any reason why this can not be merged other than the timing
> > registers goo (which I believe shall stay as in the datasheet until we
> > figure out if it's even reasonable to add some computation there).
> 
> I assume this is a question for Wolfram.  But I guess part of the reason
> is there is still one comment from me staying unresolved.

Shawn, I just re-tested the i2c with mpg123 playing "MPEG 1.0 layer III, VBR, 
44100 Hz joint-stereo" and it worked on a first try ... can you retest please?

Best regards,
Marek Vasut