[PATCH 1/3] ARM: dt: tegra: seaboard: add regulators

[Laxman Dewangan]

On Saturday 23 June 2012 04:44 AM, Stephen Warren wrote:
> From: Stephen Warren<swarren at nvidia.com>
>
> Seaboard uses a TPS6586x regulator. Instantiate this, and hook up a
> couple of fixed GPIO-controlled regulators too.
>
> The regulator configurations were mostly taken from the ChromeOS 3.2
> kernel. Exceptions are:
>
> * The schematic lists a fixed voltage for each rail, whereas the ChromeOS
>    kernel lists a range for many rails. I used the values from the ChromeOS
>    kernel in all cases, since I know the board file there is the most
>    complete available for this hardware.
>
> * The vdd_1v2 fixed regulator is present only in the schematic. So, I added
>    this based on the schematic.
>
> * A 3.3v fixed regulator using GPIO3 of the TPS6586x is present in the
>    ChromeOS kernel, but not in the schematic. So, I dropped this based on
>    the schematic.
>
> Signed-off-by: Stephen Warren<swarren at nvidia.com>
> ---

Acked-by: Laxman Dewangan <ldewangan at nvidia.com>

I think this series very much depends on the series
[PATCH V3 0/3] regulator: dt: add policy to match regulator with prop 
"regulator-compatible"


> +				regulator at 3 {
> +					reg =<3>;
> +					regulator-compatible = "ldo0";
> +					regulator-name = "vdd_ldo0";
> +					regulator-min-microvolt =<1250000>;
> +					regulator-max-microvolt =<3300000>;
> +					vin-supply =<&sm2_reg>;

I think support for vin-supply is still not there for this regulator in 
driver.