[PATCH] ARM: ux500: bump i2c bus speed to 400kHz

[Marek Vasut]

Dear Linus Walleij,

> From: Linus Walleij <linus.walleij at linaro.org>
> 
> Some recent discussion revealed inconsistency in the board file
> for the MOP500 family. The board can very well do 400kHz on
> the I2C busses, so make it do that.

Shouldn't this be controlled by DT? Some of the i2c devices can't do 400kHz.

> Cc: Srinidhi Kasagar <srinidhi.kasagar at stericsson.com>
> Cc: Lee Jones <lee.jones at linaro.org>
> Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
> ---
>  arch/arm/mach-ux500/board-mop500.c |   10 +++++-----
>  1 file changed, 5 insertions(+), 5 deletions(-)
> 
> diff --git a/arch/arm/mach-ux500/board-mop500.c
> b/arch/arm/mach-ux500/board-mop500.c index 9c74ac5..e441bd7 100644
> --- a/arch/arm/mach-ux500/board-mop500.c
> +++ b/arch/arm/mach-ux500/board-mop500.c
> @@ -354,13 +354,13 @@ static struct nmk_i2c_controller u8500_i2c##id##_data
> = { \ /*
>   * The board uses 4 i2c controllers, initialize all of
>   * them with slave data setup time of 250 ns,
> - * Tx & Rx FIFO threshold values as 8 and standard
> + * Tx & Rx FIFO threshold values as 1 resp. 8 and fast
>   * mode of operation
>   */
> -U8500_I2C_CONTROLLER(0, 0xe, 1, 8, 100000, 200, I2C_FREQ_MODE_FAST);
> -U8500_I2C_CONTROLLER(1, 0xe, 1, 8, 100000, 200, I2C_FREQ_MODE_FAST);
> -U8500_I2C_CONTROLLER(2,	0xe, 1, 8, 100000, 200, I2C_FREQ_MODE_FAST);
> -U8500_I2C_CONTROLLER(3,	0xe, 1, 8, 100000, 200, I2C_FREQ_MODE_FAST);
> +U8500_I2C_CONTROLLER(0, 0xe, 1, 8, 400000, 200, I2C_FREQ_MODE_FAST);
> +U8500_I2C_CONTROLLER(1, 0xe, 1, 8, 400000, 200, I2C_FREQ_MODE_FAST);
> +U8500_I2C_CONTROLLER(2,	0xe, 1, 8, 400000, 200, I2C_FREQ_MODE_FAST);
> +U8500_I2C_CONTROLLER(3,	0xe, 1, 8, 400000, 200, I2C_FREQ_MODE_FAST);
> 
>  static void __init mop500_i2c_init(struct device *parent)
>  {

Best regards,
Marek Vasut