[PATCH 2/3] ARM: OMAP2+: onenand: cleanup for gpmc driver conversion

[Jon Hunter]

Hi Afzal,

On 06/13/2012 12:03 AM, Mohammed, Afzal wrote:
> Hi Jon,
> 
> On Tue, Jun 12, 2012 at 23:00:48, Hunter, Jon wrote:
> 
>> On 06/12/2012 01:16 AM, Mohammed, Afzal wrote:
>>> With the existing code, set_async was done as part of set_sync, hence
>>> requiring GPMC to be configured twice after driver takes control, with
>>> your suggestion too, GPMC would have to be configured twice.
>>
>> I am just suggesting that you place the call to set_async_mode in the
>> gpmc_onenand_setup() instead of the gpmc_onenand_init() and remove the
>> calls from set_sync (like you have done). So I don't see that these
>> would configure the GPMC twice.
> 
> As gpmc_onenand_setup is a callback by onenand driver, we would have
> lost the opportunity to configure onenand before driver is probed.

Is that a problem? Looks like it is called early in the probe and so I
would hope no one is attempting to access the onenand itself before the
probe has completed.

> This would cause requirement of double GPMC configuring and we lost
> the opportunity to configure GPMC before driver is probed.

I am not convinced we need to. Furthermore with your change you do not
actually set async mode in the onenand until _set_sync() is called.

> And the first step for onenand configuration is always to set it
> to async mode (with the way it is done now), so it seems reasonable
> to rely on normal GPMC configuration for async & then do reconfigure
> for sync.

Yes but as far as I can see, it seems that this is the intent of the
onenand_setup() function to perform the necessary initialisation.

Have you tested onenand? Do you have a board with onenand?

Cheers
Jon