[RFC PATCH 0/3] usb: musb: add new phy driver

[ABRAHAM, KISHON VIJAY]

Hi,

On Tue, Jun 12, 2012 at 4:18 PM, Felipe Balbi <balbi at ti.com> wrote:
> On Wed, May 30, 2012 at 08:04:23PM +0530, Kishon Vijay Abraham I wrote:
>> This series adds a new usb2 phy driver. The device for which is created
>> by the ocp2scp driver. This also uses control module driver.
>>
>> This series converts twl6030 as a comparator driver (previously it was
>> also the phy driver) and makes use of omap-usb2 as the phy driver.
>>
>> Instead of notification mechanism by power chip to omap glue to pass detection
>> of any events, an export API has been added in omap glue. Both twl4030 and
>> twl6030 will call to this API to pass any event. (twl6030 is used in omap4 and
>> twl4030 is used in omap3).
>>
>> This series depends on:
>> *[RFC PATCH 00/11] OMAP System Control Module* patch series
>> However System Control Module driver has only dt support, so wouldn't
>> be able to test this patch series. However I'll adapt omap usb2 phy
>> driver and musb driver for dt and send it asap to the list.
>>
>> This series also depends on:
>> *[PATCH v3 0/3] usb: multi-phy support* patch series
>> *[RFC PATCH 0/5] omap: add ocp2scp as a misc driver* patch series
>>
>> Compile tested only.
>
> are we getting new version of this series ?

Yes. I'm planning to send a new version with only dt support by next week.

Thanks
Kishon