[PATCH] MXS: Add DENX M28 dts file

[Marek Vasut]

Dear Huang Shijie,

> 于 2012年06月11日 13:45, Shawn Guo 写道:
> > On Fri, Jun 08, 2012 at 09:03:09PM +0200, Marek Vasut wrote:
> >>> I just applied Huang's gpmi changes below.  Can you please rebase the
> >>> the patch on top of it?  If you have the same pin setup as imx28-evk,
> >>> we can save above data completely.
> >>> 
> >>> http://thread.gmane.org/gmane.linux.ports.arm.kernel/169351
> >> 
> >> Well, GPMI NAND doens't work for me (AGAIN). Screw this, I'm not
> >> debuging it for the third damn time only to be told to rebase it again
> >> and that all I did was for naught. Sorry
> > 
> > Hmm, I was told by Huang that GPMI NAND works for him.  As I do not
> 
> sorry. It can not works now. :(
> 
> There is a bug in the GPMI-NAND driver( i guess).
> 
> The pinmux, clocks, IO resources are all correct.
> And the ECC read page/ ECC write page are ok too.
> 
> But the UBIFS can not works.

I sent you that link ... it might be the problem you're facing. And if it isn't, 
then you should fix that too, since you're depending on undefined behavior 
there.

> 
> I am debugging it now.
> 
> Huang Shijie
> 
> > have NAND device to play, can you guys aligned here?

Best regards,
Marek Vasut