[PATCH v3 00/12] add imx usb driver for mx28/6x
balbi at ti.com
Tue Jun 5 11:02:13 EDT 2012
On Fri, May 25, 2012 at 10:24:13AM +0800, Richard Zhao wrote:
> The work is based on ci13xxx rework done by Alexander Shishkin.
> - this version only support host
> - usbotg controler works at host role
> Changes since V2:
> - Rebase to Alex's tree
> - Use regulator to control vbus power
> - Remove ARCH check in Kconfig, but add OF_DEV check.
> - Other changes according laster version comments.
> Richard Zhao (12):
> usb: otg: add notify_connect/notify_disconnect callback
> usb: chipidea: permit driver bindings pass phy pointer
> usb: ehci-hcd: notify phy when connect change
> usb: otg: add basic mxs phy driver support
> usb: chipidea: add imx platform driver
> ARM: imx6q: correct device name of usbphy and usb controller clock
> ARM: imx6q: add config-on-boot gpios
> ARM: imx6q: add usbphy clocks
> ARM: imx6q: disable usb charger detector
> ARM: dts: imx6q-sabrelite: add usb devices
> ARM: mxs: clk_register_clkdev mx28 usb clocks
> ARM: dts: imx28-evk: add usb devices
how are we going to handle these series ? drivers/usb/otg/* parts are
mostly ok (I need to look deeper) but if I take drivers/usb/otg/* we
will have to delay drivers/usb/chipidea I guess...
So someone would have to take the whole series ? Who will be that
person? Alex, will it be you ?
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 836 bytes
Desc: Digital signature
More information about the linux-arm-kernel