[PATCH v2] omap: dma: Clear status registers on enable/disable irq.

[Tony Lindgren]

* Janusz Krzysztofik <jkrzyszt at tis.icnet.pl> [120604 15:01]:
> On Tue, 15 May 2012 14:35:08 Oleg Matcovschi wrote:
> > Use omap_disable_channel_irq() function instead of directly accessing CICR.
> > The omap_disable_chanel_irq() function clears pending interrupts
> > and disables interrupt on channel.
> > Functions omap2_enable_irq_lch()/omap2_disable_irq_lch() clear interrupt
> > status register.
> > 
> > 
> > Signed-off-by: Oleg Matcovschi <oleg.matcovschi at ti.com>
> > ---
> > v1 initial revision
> > v2 Review by Tony Lindgren
> 
> My Tested-by: on OMAP1 still valid for v2 if you care.

OK good to hear, will add that.

Regards,

Tony