[PATCH] ohci-nxp: Use ohci_finish_controller_resume()

[Alan Stern]

On Sun, 3 Jun 2012, Roland Stigge wrote:

> OHCI drivers are supposed to use ohci_finish_controller_resume(). This patch
> adds respective suspend and resume code to ohci-nxp. The following compiler
> warning is fixed this way:
> 
> drivers/usb/host/ohci-hub.c:321: warning: 'ohci_finish_controller_resume'
> defined but not used

This is not a correct description of the patch.  A correct description 
would be something like:

	Add suspend/resume support to the ohci-nxp driver.

The compiler warning needs a completely different fix; 
ohci_finish_controller_resume should be given a __maybe_unused 
annotation.

Alan Stern

> Signed-off-by: Roland Stigge <stigge at antcom.de>
> 
> ---
> Applies to v3.5-rc1
> 
>  drivers/usb/host/ohci-nxp.c |   21 +++++++++++++++++++++
>  1 file changed, 21 insertions(+)
> 
> --- linux-2.6.orig/drivers/usb/host/ohci-nxp.c
> +++ linux-2.6/drivers/usb/host/ohci-nxp.c
> @@ -432,6 +432,23 @@ static int usb_hcd_nxp_remove(struct pla
>  	return 0;
>  }
>  
> +#ifdef CONFIG_PM
> +static int usb_hcd_suspend(struct platform_device *pdev, pm_message_t message)
> +{
> +	clk_disable(usb_clk);
> +	return 0;
> +}
> +
> +static int usb_hcd_resume(struct platform_device *pdev)
> +{
> +	struct usb_hcd *hcd = platform_get_drvdata(pdev);
> +
> +	clk_enable(usb_clk);
> +	ohci_finish_controller_resume(hcd);
> +	return 0;
> +}
> +#endif
> +
>  /* work with hotplug and coldplug */
>  MODULE_ALIAS("platform:usb-ohci");
>  
> @@ -451,5 +468,9 @@ static struct platform_driver usb_hcd_nx
>  	},
>  	.probe = usb_hcd_nxp_probe,
>  	.remove = usb_hcd_nxp_remove,
> +#ifdef CONFIG_PM
> +	.suspend = usb_hcd_suspend,
> +	.resume = usb_hcd_resume,
> +#endif
>  };