[PATCH 5/7] ARM: mxs: convert tx28 board to device tree

Shawn Guo shawn.guo at linaro.org
Fri Jul 13 03:14:18 EDT 2012


Hi Lothar,

On Mon, Jul 09, 2012 at 03:04:53PM +0200, Lothar Waßmann wrote:
> This doesn't work at least because the pins that are used for PHY
> strap options need to be reconfigured for their FEC functionality
> after releasing the PHY reset. But even after adding the missing
> reconfiguration the ethernet PHY does not work.
> 
Can you please test the branch below to see if ethernet PHY works?

  git://git.linaro.org/people/shawnguo/linux-2.6.git mxs/dt/tx28

I hope I have addressed the issue with pin configuration there.
But I'm not sure if "enet_out" clock needs to be enabled on tx28.
I have enabled it in the code above.  You need to remove
enable_clk_enet_out call from tx28_init, if it's not needed.

-- 
Regards,
Shawn




More information about the linux-arm-kernel mailing list