[PATCH 5/7] ARM: mxs: convert tx28 board to device tree

[Shawn Guo]

On Mon, Jul 09, 2012 at 03:04:53PM +0200, Lothar Waßmann wrote:
> This doesn't work at least because the pins that are used for PHY
> strap options need to be reconfigured for their FEC functionality
> after releasing the PHY reset.

Ah, right.  I missed that the pins used for PHY strap options are
actually FEC pins.

> But even after adding the missing
> reconfiguration the ethernet PHY does not work.
> 
How did you do that?  Since the pins will be switched between GPIO and
FEC functionality, they should not be defined in "hog" node any more.
It becomes difficult.

> Since I currently don't have time to delve deeper into this, you may
> drop the TX28 board support until I get time to do the conversion to
> DT myself.
> 
I plan to convert all the board files to DT and make the whole mach-mxs
DT only, and then more cleanup works can be proceeded.  It's much
preferred you can work on it yourself, if you can get to this soon.
Otherwise, I can remotely work it out with your help on testing? ;)

-- 
Regards,
Shawn