[PATCH WIP] ARM: kirkwood: covert orion-spi to fdt.
Jason Cooper
jason at lakedaemon.net
Mon Feb 27 17:31:32 EST 2012
On the Globalscale Dreamplug (Marvell Kirkwood Development Platform),
2MB of NOR flash are used to hold the bootloader, bootloader
environment, and devicetree blob. It is connected via spi.
Signed-off-by: Jason Cooper <jason at lakedaemon.net>
---
Notes:
- checkpatch clean.
- compiles, boots, registers partitions correctly.
arch/arm/boot/dts/kirkwood-dreamplug.dts | 34 +++++++++++++
arch/arm/mach-kirkwood/board-dt.c | 40 ----------------
arch/arm/mach-kirkwood/common.c | 11 ++++
drivers/spi/spi-orion.c | 75 ++++++++++++++++++++++++++----
4 files changed, 111 insertions(+), 49 deletions(-)
diff --git a/arch/arm/boot/dts/kirkwood-dreamplug.dts b/arch/arm/boot/dts/kirkwood-dreamplug.dts
index 8a5dff8..bdf2ddc 100644
--- a/arch/arm/boot/dts/kirkwood-dreamplug.dts
+++ b/arch/arm/boot/dts/kirkwood-dreamplug.dts
@@ -22,4 +22,38 @@
interrupts = <33>;
clock-frequency = <200000000>;
};
+
+ spi at f1010600 {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ compatible = "marvell,orion-spi";
+ reg = <0xf1010600 0x1ff>;
+ clock-frequency = <200000000>;
+
+ flash at 0 {
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ compatible = "macronix,mx25l1606e", "jedec-flash";
+
+ spi-max-frequency = <50000000>;
+ reg = <0>;
+
+ partition at 0 {
+ label = "U-Boot";
+ reg = <0x0 0x100000>;
+ };
+
+ partition at 100000 {
+ label = "U-Boot Environment";
+ reg = <0x100000 0x080000>;
+ };
+
+ partition at 180000 {
+ label = "Flattened Device Tree";
+ reg = <0x180000 0x080000>;
+ };
+ };
+ };
};
diff --git a/arch/arm/mach-kirkwood/board-dt.c b/arch/arm/mach-kirkwood/board-dt.c
index fbe6405..4960e63 100644
--- a/arch/arm/mach-kirkwood/board-dt.c
+++ b/arch/arm/mach-kirkwood/board-dt.c
@@ -39,42 +39,6 @@ static struct of_device_id kirkwood_dt_match_table[] __initdata = {
{ }
};
-struct mtd_partition dreamplug_partitions[] = {
- {
- .name = "u-boot",
- .size = SZ_512K,
- .offset = 0,
- },
- {
- .name = "u-boot env",
- .size = SZ_64K,
- .offset = SZ_512K + SZ_512K,
- },
- {
- .name = "dtb",
- .size = SZ_64K,
- .offset = SZ_512K + SZ_512K + SZ_512K,
- },
-};
-
-static const struct flash_platform_data dreamplug_spi_slave_data = {
- .type = "mx25l1606e",
- .name = "spi_flash",
- .parts = dreamplug_partitions,
- .nr_parts = ARRAY_SIZE(dreamplug_partitions),
-};
-
-static struct spi_board_info __initdata dreamplug_spi_slave_info[] = {
- {
- .modalias = "m25p80",
- .platform_data = &dreamplug_spi_slave_data,
- .irq = -1,
- .max_speed_hz = 50000000,
- .bus_num = 0,
- .chip_select = 0,
- },
-};
-
static struct mv643xx_eth_platform_data dreamplug_ge00_data = {
.phy_addr = MV643XX_ETH_PHY_ADDR(0),
};
@@ -140,10 +104,6 @@ static void __init dreamplug_init(void)
*/
kirkwood_mpp_conf(dreamplug_mpp_config);
- spi_register_board_info(dreamplug_spi_slave_info,
- ARRAY_SIZE(dreamplug_spi_slave_info));
- kirkwood_spi_init();
-
kirkwood_ehci_init();
kirkwood_ge00_init(&dreamplug_ge00_data);
kirkwood_ge01_init(&dreamplug_ge01_data);
diff --git a/arch/arm/mach-kirkwood/common.c b/arch/arm/mach-kirkwood/common.c
index cc15426..b041af3 100644
--- a/arch/arm/mach-kirkwood/common.c
+++ b/arch/arm/mach-kirkwood/common.c
@@ -15,6 +15,7 @@
#include <linux/ata_platform.h>
#include <linux/mtd/nand.h>
#include <linux/dma-mapping.h>
+#include <linux/of.h>
#include <net/dsa.h>
#include <asm/page.h>
#include <asm/timex.h>
@@ -481,6 +482,9 @@ static int __init kirkwood_clock_gate(void)
{
unsigned int curr = readl(CLOCK_GATING_CTRL);
u32 dev, rev;
+#ifdef CONFIG_OF
+ struct device_node *dp;
+#endif
kirkwood_pcie_id(&dev, &rev);
printk(KERN_DEBUG "Gating clock of unused units\n");
@@ -524,6 +528,13 @@ static int __init kirkwood_clock_gate(void)
} else /* keep this bit set for devices that don't have PCIe1 */
kirkwood_clk_ctrl |= CGC_PEX1;
+#ifdef CONFIG_OF
+ dp = of_find_node_by_path("/");
+ if (of_device_is_available(of_find_compatible_node(dp, NULL,
+ "marvell,orion-spi")))
+ kirkwood_clk_ctrl |= CGC_RUNIT;
+#endif
+
/* Now gate clock the required units */
writel(kirkwood_clk_ctrl, CLOCK_GATING_CTRL);
printk(KERN_DEBUG " after: 0x%08x\n", readl(CLOCK_GATING_CTRL));
diff --git a/drivers/spi/spi-orion.c b/drivers/spi/spi-orion.c
index 13448c8..2ee5e16 100644
--- a/drivers/spi/spi-orion.c
+++ b/drivers/spi/spi-orion.c
@@ -18,6 +18,7 @@
#include <linux/spi/spi.h>
#include <linux/spi/orion_spi.h>
#include <linux/module.h>
+#include <linux/of_device.h>
#include <asm/unaligned.h>
#define DRIVER_NAME "orion_spi"
@@ -101,10 +102,24 @@ static int orion_spi_baudrate_set(struct spi_device *spi, unsigned int speed)
u32 prescale;
u32 reg;
struct orion_spi *orion_spi;
+#ifdef CONFIG_OF
+ const __be32 *prop;
+ int len;
+#endif
orion_spi = spi_master_get_devdata(spi->master);
+#ifdef CONFIG_OF
+ prop = of_get_property(spi->master->dev.of_node, "clock-frequency",
+ &len);
+ if (!prop || len < sizeof(*prop)) {
+ pr_debug("fdt missing 'clock-frequency' property.\n");
+ return -EINVAL;
+ }
+ tclk_hz = be32_to_cpup(prop);
+#else
tclk_hz = orion_spi->spi_info->tclk;
+#endif
/*
* the supported rates are: 4,6,8...30
@@ -360,7 +375,11 @@ static int orion_spi_setup(struct spi_device *spi)
orion_spi = spi_master_get_devdata(spi->master);
/* Fix ac timing if required. */
+#ifdef CONFIG_OF
+ if (of_find_property(spi->master->dev.of_node, "spi-clock-fix", NULL))
+#else
if (orion_spi->spi_info->enable_clock_fix)
+#endif
orion_spi_setbits(orion_spi, ORION_SPI_IF_CONFIG_REG,
(1 << 14));
@@ -449,15 +468,47 @@ msg_rejected:
return -EINVAL;
}
+#ifdef CONFIG_OF
+static struct of_device_id spi_orion_of_match_table[] __devinitdata = {
+ { .compatible = "marvell,orion-spi", },
+ {}
+};
+MODULE_DEVICE_TABLE(of, spi_orion_of_match_table);
+#else /* CONFIG_OF */
+#define spi_orion_of_match_table NULL
+#endif /* CONFIG_OF */
+
+static struct platform_driver orion_spi_driver = {
+ .driver = {
+ .name = DRIVER_NAME,
+ .owner = THIS_MODULE,
+ .of_match_table = spi_orion_of_match_table,
+ },
+ .remove = __exit_p(orion_spi_remove),
+};
+
static int __init orion_spi_probe(struct platform_device *pdev)
{
struct spi_master *master;
struct orion_spi *spi;
struct resource *r;
- struct orion_spi_info *spi_info;
int status = 0;
+#ifdef CONFIG_OF
+ const __be32 *prop;
+ int tclk;
+ int len;
+#else
+ struct orion_spi_info *spi_info;
spi_info = pdev->dev.platform_data;
+#endif
+
+#ifdef CONFIG_OF
+ orion_spi_wq = create_singlethread_workqueue(
+ orion_spi_driver.driver.name);
+ if (orion_spi_wq == NULL)
+ return -ENOMEM;
+#endif
master = spi_alloc_master(&pdev->dev, sizeof *spi);
if (master == NULL) {
@@ -474,15 +525,29 @@ static int __init orion_spi_probe(struct platform_device *pdev)
master->setup = orion_spi_setup;
master->transfer = orion_spi_transfer;
master->num_chipselect = ORION_NUM_CHIPSELECTS;
+ master->dev.of_node = pdev->dev.of_node;
dev_set_drvdata(&pdev->dev, master);
spi = spi_master_get_devdata(master);
spi->master = master;
+#ifdef CONFIG_OF
+ prop = of_get_property(master->dev.of_node, "clock-frequency", &len);
+ if (!prop || len < sizeof(*prop)) {
+ pr_debug("fdt missing 'clock-frequency' property.\n");
+ status = -EINVAL;
+ goto out;
+ }
+ tclk = be32_to_cpup(prop);
+
+ spi->max_speed = DIV_ROUND_UP(tclk, 4);
+ spi->min_speed = DIV_ROUND_UP(tclk, 30);
+#else
spi->spi_info = spi_info;
spi->max_speed = DIV_ROUND_UP(spi_info->tclk, 4);
spi->min_speed = DIV_ROUND_UP(spi_info->tclk, 30);
+#endif
r = platform_get_resource(pdev, IORESOURCE_MEM, 0);
if (r == NULL) {
@@ -541,14 +606,6 @@ static int __exit orion_spi_remove(struct platform_device *pdev)
MODULE_ALIAS("platform:" DRIVER_NAME);
-static struct platform_driver orion_spi_driver = {
- .driver = {
- .name = DRIVER_NAME,
- .owner = THIS_MODULE,
- },
- .remove = __exit_p(orion_spi_remove),
-};
-
static int __init orion_spi_init(void)
{
orion_spi_wq = create_singlethread_workqueue(
--
1.7.3.4
More information about the linux-arm-kernel
mailing list