[PATCH 0/2 v6] arm: kirkwood: add dreamplug/devicetree support

[Arnd Bergmann]

On Monday 27 February 2012, Jason Cooper wrote:
> This patch series provides initial support for devicetree on kirkwood for the
> dreamplug platform.  After discussing the approach with Arnd Bergman last week
> at ELC, we decided to take an incremental approach to the conversion.  First, I
> would detect that we were on the dreamplug via the devicetree blob.  Then,
> configure uart0 via devicetree.  We chose the uart since it is already well
> supported under devicetree.
> 
> This patch series has been boot-tested on the dreamplug.
> 
> In a future patch series, I plan to migrate spi/flash/partitions over to
> devicetree.
> 
> When the migration is complete, board-dt.c will not be specific to the
> dreamplug, and dts files can be written for all of the other kirkwood boards.
> 
> Jason Cooper (2):
>   arm: kirkwood: add dreamplug (fdt) support.
>   arm: kirkwood: convert uart0 to devicetree.

Applied to the kirkwood/board branch and pulled into next/boards.

Great work!

I've made two trivial manual changes, please do these yourself next time:

1. Subject should start with "ARM: kirkwood:", not "arm: kirkwood:" by
   convention.

2. Nico and I had both replied with "Acked-by:". When you get one of
   these replies, add that line under your "Signed-off-by:" line.

If you have more changes for dreamplug, please submit those on top of
these patches now.

	Arnd