[PATCH v2 4/4] arm/dts: OMAP3: Add mmc controller nodes and board data

[Rajendra Nayak]

On Friday 24 February 2012 12:27 AM, Tony Lindgren wrote:
>> --- a/arch/arm/boot/dts/omap3.dtsi
>> +++ b/arch/arm/boot/dts/omap3.dtsi
>> @@ -113,5 +113,31 @@
>>   			#size-cells =<0>;
>>   			ti,hwmods = "i2c3";
>>   		};
>> +
>> +		mmc1: mmc at 1 {
>> +			compatible = "ti,omap2-hsmmc";
>> +			ti,hwmods = "mmc1";
>> +			ti,dual-volt;
>> +		};
>> +
>> +		mmc2: mmc at 2 {
>> +			compatible = "ti,omap2-hsmmc";
>> +			ti,hwmods = "mmc2";
>> +		};
>> +
>> +		mmc3: mmc at 3 {
>> +			compatible = "ti,omap2-hsmmc";
>> +			ti,hwmods = "mmc3";
>> +		};
>> +
>> +		mmc4: mmc at 4 {
>> +			compatible = "ti,omap2-hsmmc";
>> +			ti,hwmods = "mmc4";
>> +		};
>> +
>> +		mmc5: mmc at 5 {
>> +			compatible = "ti,omap2-hsmmc";
>> +			ti,hwmods = "mmc5";
>> +		};
>>   	};
>>   };
>
> These all should all be "ti,omap3-hsmmc" I guess?

Well, I defined the binding such that both omap2 and omap3
can use the same compatible "ti,omap2-hsmmc" since there is
no difference in the way they are defined or handled. If thats
confusing, I can have separate compatibles.
Btw, I guess we do the same with a few other re-used IPs as well,
I just checked and mcpsi does the same.

>
> Tony