[PATCH 3/5] gpio/omap: Add DT support to GPIO driver

[Rob Herring]

On 02/22/2012 08:31 AM, Cousson, Benoit wrote:
> On 2/22/2012 3:23 PM, Rob Herring wrote:
>> On 02/15/2012 10:04 AM, Benoit Cousson wrote:
>>> Adapt the GPIO driver to retrieve information from a DT file.
>>>
>>> Allocate the irq_base dynamically and rename bank->virtual_irq_start
>>> to bank->irq_base.
>>> Change irq_base type to int instead of u16 to match irq_alloc_descs
>>> output.
>>>
>>> Add documentation for GPIO properties specific to OMAP.
>>>
>>> Signed-off-by: Benoit Cousson<b-cousson at ti.com>
>>> Cc: Tarun Kanti DebBarma<tarun.kanti at ti.com>
>>
>> One comment below, but otherwise:
>>
>> Acked-by: Rob Herring<rob.herring at calxeda.com>
>>
>>> ---
>>>   .../devicetree/bindings/gpio/gpio-omap.txt         |   30 +++++
>>>   drivers/gpio/gpio-omap.c                           |  121
>>> ++++++++++++++++++--
>>>   2 files changed, 142 insertions(+), 9 deletions(-)
>>>   create mode 100644
>>> Documentation/devicetree/bindings/gpio/gpio-omap.txt
>>>
>>> diff --git a/Documentation/devicetree/bindings/gpio/gpio-omap.txt
>>> b/Documentation/devicetree/bindings/gpio/gpio-omap.txt
>>> new file mode 100644
>>> index 0000000..c1b3100
>>> --- /dev/null
>>> +++ b/Documentation/devicetree/bindings/gpio/gpio-omap.txt
>>> @@ -0,0 +1,30 @@
>>> +OMAP GPIO controller bindings
>>> +
>>> +Required properties:
>>> +- compatible:
>>> +  - "ti,omap2-gpio" for OMAP2 controllers
>>> +  - "ti,omap3-gpio" for OMAP3 controllers
>>> +  - "ti,omap4-gpio" for OMAP4 controllers
>>> +- #gpio-cells : Should be two.
>>> +  - first cell is the pin number
>>> +  - second cell is used to specify optional parameters (unused)
>>> +- gpio-controller : Marks the device node as a GPIO controller.
>>> +- #interrupt-cells : Should be one
>>
>> There's no level/edge settings for gpios?
> 
> That's a good question, because I was wondering as well :-)
> 
> I did no see how it was done in other GPIO implementation.

There's not really a good example that I've found. Many gpio nodes don't
even have "interrupt-controller" set.

So if you have an irq_set_type function for gpio's, then you should have
2 cells.

Rob