[PATCH v2 18/19] ARM: at91/board-dt: drop default console
Nicolas Ferre
nicolas.ferre at atmel.com
Wed Feb 22 04:39:44 EST 2012
From: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
This default console mechanism is not used if the console is selected
by command line (console= parameter).
Dropping this will simplify the compilation of multiple SoC in the same
kernel image.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre at atmel.com>
---
arch/arm/mach-at91/at91sam9x5.c | 3 ---
arch/arm/mach-at91/board-dt.c | 6 ------
2 files changed, 0 insertions(+), 9 deletions(-)
diff --git a/arch/arm/mach-at91/at91sam9x5.c b/arch/arm/mach-at91/at91sam9x5.c
index 90bb7ec..d17d426 100644
--- a/arch/arm/mach-at91/at91sam9x5.c
+++ b/arch/arm/mach-at91/at91sam9x5.c
@@ -318,9 +318,6 @@ void __init at91sam9x5_initialize(void)
/* --------------------------------------------------------------------
* AT91SAM9x5 devices (temporary before modification of code)
* -------------------------------------------------------------------- */
-void __init at91_register_uart(unsigned id, unsigned portnr, unsigned pins) {}
-void __init at91_set_serial_console(unsigned portnr) {}
-
void __init at91_add_device_nand(struct atmel_nand_data *data) {}
/* --------------------------------------------------------------------
diff --git a/arch/arm/mach-at91/board-dt.c b/arch/arm/mach-at91/board-dt.c
index 0579315..08c8ad8 100644
--- a/arch/arm/mach-at91/board-dt.c
+++ b/arch/arm/mach-at91/board-dt.c
@@ -38,12 +38,6 @@ static void __init ek_init_early(void)
{
/* Initialize processor: 12.000 MHz crystal */
at91_initialize(12000000);
-
- /* DGBU on ttyS0. (Rx & Tx only) */
- at91_register_uart(0, 0, 0);
-
- /* set serial console to ttyS0 (ie, DBGU) */
- at91_set_serial_console(0);
}
/* det_pin is not connected */
--
1.7.9
More information about the linux-arm-kernel
mailing list