[PATCH 3/9] ARM/USB: at91/ohci-at91: remove the use of irq_to_gpio
Nicolas Ferre
nicolas.ferre at atmel.com
Fri Feb 17 04:41:32 EST 2012
On 02/13/2012 03:43 PM, Nicolas Ferre :
> irq_to_gpio() macro will be removed from AT91 GPIO interrupt
> controller. So we replace it with the use of gpio_to_irq()
> and a reworked test.
>
> Signed-off-by: Nicolas Ferre <nicolas.ferre at atmel.com>
> Acked-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
> Cc: Thomas Petazzoni <thomas.petazzoni at free-electrons.com>
> Cc: linux-usb at vger.kernel.org
Hi Greg,
I would like to queue this patch through arm-soc git tree (with all AT91
material of this patch series).
So, can I have your "Acked-by" on this one?
> ---
> drivers/usb/host/ohci-at91.c | 5 +++--
> 1 files changed, 3 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/usb/host/ohci-at91.c b/drivers/usb/host/ohci-at91.c
> index 77afabc..8e855eb 100644
> --- a/drivers/usb/host/ohci-at91.c
> +++ b/drivers/usb/host/ohci-at91.c
> @@ -448,10 +448,11 @@ static irqreturn_t ohci_hcd_at91_overcurrent_irq(int irq, void *data)
>
> /* From the GPIO notifying the over-current situation, find
> * out the corresponding port */
> - gpio = irq_to_gpio(irq);
> for (port = 0; port < ARRAY_SIZE(pdata->overcurrent_pin); port++) {
> - if (pdata->overcurrent_pin[port] == gpio)
> + if (gpio_to_irq(pdata->overcurrent_pin[port]) == irq) {
> + gpio = pdata->overcurrent_pin[port];
> break;
> + }
> }
>
> if (port == ARRAY_SIZE(pdata->overcurrent_pin)) {
Thanks, best regards,
--
Nicolas Ferre
More information about the linux-arm-kernel
mailing list