[PATCH 2/4 v2] ARM: at91: sam9g20 add i2c DT support

[Jean-Christophe PLAGNIOL-VILLARD]

for now on use i2c-gpio driver on the same pin as the hardware IP

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
Cc: Nicolas Ferre <nicolas.ferre at atmel.com>
Cc: devicetree-discuss at lists.ozlabs.org
---
v2:

	update DT bindings

Best Regards,
J.
 arch/arm/boot/dts/at91sam9g20.dtsi |   13 +++++++++++++
 1 files changed, 13 insertions(+), 0 deletions(-)

diff --git a/arch/arm/boot/dts/at91sam9g20.dtsi b/arch/arm/boot/dts/at91sam9g20.dtsi
index f8f4627..81f8615 100644
--- a/arch/arm/boot/dts/at91sam9g20.dtsi
+++ b/arch/arm/boot/dts/at91sam9g20.dtsi
@@ -220,6 +220,19 @@
 				status = "disabled";
 			};
 
+			i2c-gpio at 0 {
+				compatible = "i2c-gpio";
+				gpios = <&pioA 23 0 /* sda */
+					 &pioA 24 0 /* scl */
+					>;
+				i2c-gpio,sda-open-drain;
+				i2c-gpio,scl-open-drain;
+				udelay = <2>;		/* ~100 kHz */
+				#address-cells = <1>;
+				#size-cells = <0>;
+				status = "disabled";
+			};
+
 		};
 	};
 };
-- 
1.7.7