[PATCH] ux500 : decouple/recouple gic from the PRCMU

Daniel Lezcano daniel.lezcano at linaro.org
Tue Feb 7 04:22:29 EST 2012


On 02/07/2012 09:39 AM, Rickard Andersson wrote:
> On 02/06/2012 03:10 PM, Daniel Lezcano wrote:
>> On 02/06/2012 10:19 AM, Rickard Andersson wrote:
>>> Hi!
>>>
>>> Our comments:
>> Thanks Rickard and Jonas for your comments.
>>
>>> - function names don't match commit comment disable/enable vs
>>> recouple/decouple. Decouple is a better name than disable, because GIC
>>> is not really disabled it is just disconnected.
>> Ok, that makes sense.
>>
>>> - there is no reason to place these functions inside the db8500-prcmu.c
>>> file. There is so much stuff in the PRCMU register base so we can not
>>> have everything in one file. Why not have it as it is?
>> Why spread the prcmu code when it is related to the prcmu ?
>>
>> Linus ? What do you think ?
>>
>>> - why the gic_mask function?
>> Because the register has 31 bits reserved which could be used later
>> without modifying this function.
> This is will most likely not happen. If that happens we could add that
> function then. We should remove it for now.
>>> - The original code has been updated and now looks like this:
>> That is the same code, except the while loop where, if this code
>> assumption is correct, means we will do only one iteration in the loop.
> Yes, but in theory you can be stuck forever in that loop, so please
> remove the loop.

Mmmh, can you elaborate please ? I think a comment and/or an error 
should be returned in this case, no ?

-- 
  <http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog




More information about the linux-arm-kernel mailing list