[PATCH v3 0/3] ARM/dts: omap3: Add DT support for IGEP devices

[Javier Martinez Canillas]

On Wed, Dec 12, 2012 at 11:11 AM, Benoit Cousson <b-cousson at ti.com> wrote:
> Hi Javier,
>
> On 12/12/2012 09:25 AM, Javier Martinez Canillas wrote:
>> On Mon, Dec 3, 2012 at 1:41 PM, Javier Martinez Canillas
>> <javier.martinez at collabora.co.uk> wrote:
>>> IGEP technology devices are TI OMAP3 SoC based industrial embedded
>>> and computer-on-module boards. This patch-set adds initial device
>>> tree support for these devices.
>>>
>>> The device trees allows to boot from an MMC and are working all the
>>> components that already have device tree support on OMAP3 SoCs:
>>>
>>> - MMC/SD
>>> - UARTs
>>> - GPIO LEDs
>>> - TWL4030 codec audio
>>> - pinmux/pinconf pinctrl
>>>
>>> Some peripheral are still not working such as Flash storage and
>>> Ethernet but support for these will also be included once the
>>> OMAP GPMC device tree binding patches land on mainline.
>>>
>>> This is a v3 of the patch-set that solves issues pointed out by
>>> Enric Balletbo and Benoit Cousson.
>>>
>>> The patch-set is composed of the following patches:
>>>
>>> [PATCH v3 1/3] ARM/dts: omap3: Add generic DT support for IGEP devices
>>> [PATCH v3 2/3] ARM/dts: omap3: Add support for IGEPv2 board
>>> [PATCH v3 3/3] ARM/dts: omap3: Add support for IGEP COM Module
>>>
>>> Best regards,
>>> Javier
>>> --
>>
>> Hi Benoit and Tony,
>>
>> Any comments on these?
>
> Nope, that's fine. I'll applied the series for 3.9.
>
> Thanks,
> Benoit
>
>

Great, thanks a lot for!

Best regards,
Javier